User manual YOO DIGITAL VAPYOO 900BLEU

[. . . ] € During use, always place the power base on a stable, level and horizontal surface or ironing board, and then place the iron on the power base. If the iron is placed onto the iron rest plate during in use, the iron rest plate may become a hot surface. Do not touch the iron rest plate and the soleplate until they have cooled down completely. € Never use the iron facing towards people because the steam can cause burns. [. . . ] Water tank decoration indicator light will not light up when water tank or filter are not well installed in place, and no steam escaped even if steam button is pressed. S t eam f unct i o n settin g Once the unit energized with power supply, steam indicator light automatically sets at low steam setting. press steam selection switch to change to MAX or Medium steam setting. If steam ironing is not necessary, please turn off the steam selection switch, and wait for all steam indicator light going out. Fill water tank with clean tap water refer to above filling instruction. For better performance, please immerse filter in water for several minutes before install it into the water tank) 2. Press power switch on control panel, a Beep sound will be provided and the power indicator light lights up, it shows that the unit has been connected to the power supply. Concurrently, water tank decoration indicator light will also light up. Heating indicator light turn on to indicate that the steam chamber being heated up. Low steam setting indicator light turn on to indicate steam is set at low setting. During use, it is normal that heating indicator light will cycle from on to off. This shows that steam chamber automatically keeps temperature constant. Heating indicator light at iron unit blinks slowly to indicate the unit being heated up. When the heating indicator light change to light up steadily , the desired temperature has been reached. During use, temperature indicator light sometimes blinks, and sometimes lights up steadily, it does not indicate a defects or hazard, it is just because the appliance are temperature constant. Before every first time use, it is proposed to clean iron unit as following methods: Take the iron up from the base unit, press steam button underneath the handle to allow steam ON for 20 seconds, and then OFF for 30 seconds, this cycle should be repeated for 2 times. During steam ironing, please adjust steam rate according to your requirement as indicated in the steam function setting. After use, Set the temperature setting button to “Ready indicator light” position, and place the iron back on the iron rest plate. Switch off the unit by pressing the power switch and then unplug the appliance from the outlet. Note • For every first time use, it is normal that’s a slightly vibration sound may be occurred from electrical pump inside the base unit for a few seconds when steam ironing started. It is because there is air inside the filter, it will stop till the air inside the filter has been pumped out. € During use, if steam stop escaping suddenly along with 5 BEEP sound alarm, or water tank indicator light and water filling indicator light on control panel blink. [. . . ] The set temperature has not been Allow sufficient time for iron to reached or is too low. Water tank decoration Water tank has not been installed Well install the water tank. All indicator light OFF The appliance comes into auto- Press power ON/OFF to reset it. Iron does not produce The set temperature has not been Allow sufficient time to preheat steam reached. [. . . ]