User manual X10 CR12A
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual X10 CR12A. We hope that this X10 CR12A user guide will be useful to you.
 |
Manual abstract: user guide X10 CR12A
Detailed instructions for use are in the User's Guide.
[. . . ] Installation and operating instructions for ScanCam Remote Control with Camera Scanning Feature, Model CR12A
The CR12A Remote Control sends Wireless Radio Frequency (RF) signals to any X10 Transceiver (RR501 or TM751, etc. ). [. . . ] In the default state the CR12A controls Addressable Power Supplies set to 1 thru 4. Pressing any number ON (in that group) turns that camera on and the other three cameras (in the group) off. Then, each press of either the blue UP (or DOWN) button will turn on the next (or previous) camera in the group while turning the current camera off. (You set all Cameras to the same channel as the Video Receiver connected to your TV (Channel A, B, C, D). If you press any number ON or OFF that is NOT in the group (1-4) any X10 Module set to that code turns on or off. Then if you press the BLUE UP or DOWN buttons, that Module (set to the number just pressed) brightens or dims (only affects Lamp Modules and Wall Switch Modules, not Appliance Modules).
9. To change the group of 4 codes for camera control from 1-4 to 5-8: Press (and hold) the 5-ON button then flip the 1-8/9-16 switch to the right and then back to the left. To change the group of 4 codes for camera control to 9-12: Move the slide switch to 916. [. . . ] For help or more information on setup, please visit: http://www. x10. com/support
CR12A-11/02 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE X10 CR12A
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual X10 CR12A will begin.