User manual WINCHESTER PIGEON GRADE XTR TRAP WITH WINCHOKE
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WINCHESTER PIGEON GRADE XTR TRAP WITH WINCHOKE. We hope that this WINCHESTER PIGEON GRADE XTR TRAP WITH WINCHOKE user guide will be useful to you.
 |
WINCHESTER PIGEON GRADE XTR TRAP WITH WINCHOKE : Download the complete user guide (1010 Ko) |
Manual abstract: user guide WINCHESTER PIGEON GRADE XTR TRAP WITH WINCHOKE
Detailed instructions for use are in the User's Guide.
[. . . ] Ώ Do not connect the speaker terminals to the car chassis, or connect the terminals of the right speakers with those of the left speaker. Ώ Do not connect the ground (earth) lead of this unit to the negative (–) terminal of the speaker. Connecting active speakers (with built-in amplifiers) to the speaker terminals may damage the unit. [. . . ] Note on connection If speaker and amplifier are not connected correctly, “FAILURE” appears in the display. In this case, make sure the speaker and amplifier are connected correctly. To a car’s illumination signal
This connection is only for amplifiers and a power antenna (aerial). Be sure to connect the black ground (earth) lead to a metal surface of the car first. To the +12 V power terminal which is energized
in the accessory position of the ignition switch
Vers le connecteur du signal d’éclairage de la
voiture
Raccordez d’abord le câble de mise à la masse noir à un point métallique du véhicule. Au niveau de AMP REMOTE IN de l’amplificateur de puissance en option
Parts list (
)
To the +12 V power terminal which is energized
at all times
Notes If there is no accessory position, connect to the +12 V power (battery) terminal which is energized at all times. Be sure to connect the black ground (earth) lead to a metal surface of the car first. Ώ When your car has a built-in FM/AM antenna (aerial) in the rear/ side glass, see “Notes on the control and power supply leads. The bracket and the protection collar are attached to the unit before shipping. Mounting the unit in a Japanese car ( )
You may not be able to install this unit in some makes of Japanese cars. Note To prevent malfunction, install only with the supplied screws . Fuse replacement (
)
Français
When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows again after replacement, there may be an internal malfunction. How to detach and attach the front panel ( )
Before installing the unit, detach the front panel. Mounting angle adjustment
Adjust the mounting angle to less than 45°. Removing the protection collar and the bracket ( )
Before installing the unit, remove the protection collar and the bracket from the unit. -A To detach
Before detaching the front panel, be sure to press and hold . -B To attach
Engage part of the front panel with part of the unit, as illustrated, and push the left side into position until it clicks. [. . . ] -B To attach
Engage part of the front panel with part of the unit, as illustrated, and push the left side into position until it clicks. Retrait du tour de protection et du support ( )
Avant d’installer l’appareil, retirez le tour de protection et le support de l’appareil. 2
Pinch both edges of the protection collar , then pull it out. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE WINCHESTER PIGEON GRADE XTR TRAP WITH WINCHOKE
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WINCHESTER PIGEON GRADE XTR TRAP WITH WINCHOKE will begin.