User manual WHITES ELECTRONICS SEARS 59646

[. . . ] Choose the installation location carefully so that the unit will not interfere driving. Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater duct. Use only the supplied mounting hardware for a safe and secure installation. [. . . ] Use only the supplied mounting hardware for a safe and secure installation. How to detach and attach the front panel Before installing the unit, detach the front panel. Press (RELEASE), then slide the front panel a little to the left, and pull it off towards you. Attach part A of the front panel to part B of the unit as illustrated and push the left side into position until it clicks. With the ribs on bottom con la costilla en el fondo ­a¥Y¥X¡""a/L· To support the unit Sujeción de la unidad 'T'w , , This unit is designed for negative earth 12 V DC operation only. Before making connections, disconnect the earth terminal of the car battery to avoid short circuits. Connect the yellow and red power input leads only after all other leads have been connected. To the power aerial control lead or power supply lead of an aerial booster amplifier <Notes> · It is not necessary to connect this lead if there is no power aerial or antenna booster, or with a manually-operated telescopic aerial. To the +12 V power terminal which is energised at the accessory position of the ignition key switch <Note> If there is no accessory position, connect to the +12 V power (battery) terminal which is energised at all times. To the +12 V power terminal which is energised at all times Be sure to connect the black earth lead to it first. To a metal place in the car First connect the black earth lead, then connect the yellow and red power input leads. When your car has a built-in FM/AM aerial in the rear/side glass, it is necessary to connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. [. . . ] When your car has a built-in FM/AM aerial in the rear/side glass, it is necessary to connect the power aerial control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster. Memory hold connection When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is turned off. notes on speaker connection · Before connecting the speakers, turn the unit off. [. . . ]