User manual WHIRLPOOL W5TXEWFWQ

[. . . ] Compliance with all local, state or national codes pertaining to this type of installation should be determined prior to installation. NOTE: It is possible to make the trim kit t vertical openings that are less than 74 " (189. 54 cm) must be cut from the base of both the left hand and right hand side extrusions. Grille, Bottom Assembly (1) Tools Needed Assemble the required tools and parts before starting installation. [. . . ] wARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Failure to follow these instructions can result in death, fire, or electrical shock. Before you move your refrigerator and freezer into their final location, it is important to make sure you have the proper electrical connection. Install the top trim extrusion onto the grille assembly by sliding it onto the grille extrusion at the top. It is recommended that a separate circuit serving only your refrigerator and a separate circuit serving only your freezer be provided. NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the Temperature Control to the OFF position as shown and then disconnect the refrigerator from the electrical source. NOTE: Make sure all the grille extrusions are contained within the channel of the side extrusions and the top surface of the top trim extrusion is flush with the top surface of the sides. Assemble the six grille extrusions by sliding one into the other through the tongue and groove feature as shown. Align the hole on the side extrusion with the groove on the top extrusion on each side of the grille assembly. Using the two countersunk Phillips screws, fasten the side trim to the grille assembly. Insert the screw through the predrilled hole and into the groove on each side of the grille assembly as shown. Check the level of the appliance since it may have changed when you moved it into the opening. Attach the plastic foam spacer, to the side of the appliance, so that it is flush with the top and rear edge of the cabinet as shown. NOTE: The spacer ensures that the two appliances are positioned the correct distance apart from each other. Repeat Step 3 for the other appliance until both the freezer and refrigerator are level, plumb and at the same height. Adjust the front leveler legs enough to lift the cabinet up off of the floor. NOTE: If your model is equipped with rollers, the front legs should be lowered enough to lift the rollers off of the floor to ensure that the freezer does not roll forward when the door is opened. Move Refrigerator and Freezer to Final Location WARNING Excessive Weight Hazard Use two or more people to move and install refrigerator. Slide the first appliance into the opening far enough to connect the power cord to the electrical outlet. Check the level of the appliance since it may have changed when you moved it into the opening. NOTE: Depending on the level of the floor, you may need to remove each appliance and readjust several times to achieve a satisfactory alignment. If needed, either door may be adjusted vertically by loosening the three hinge bolts, moving the hinge and retightening the bolts. [. . . ] When Moving Your Freezer or Refrigerator: Your freezer and refrigerator are heavy. When moving the appliance for cleaning or service, be sure to cover the floor with cardboard or hardboard to avoid floor damage. Do not wiggle or “walk” the appliance when trying to move it, as floor damage could occur. IMPORTANT: If the electrical outlets are not centered in the back wall of the opening, move the appliance on the opposite side of the outlets into the opening first. [. . . ]