User manual WHIRLPOOL GI6FARXXY

[. . . ] It is recommended that a separate circuit serving only your refrigerator be provided. [. . . ] NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting. See "Using the Controls. " Water: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate ice maker and water dispenser. (178. 1 cm) (174. 3 cm) (121. 9 cm) (137. 2 cm) (89. 5 cm) (83. 5 cm) (73. 7 cm) (90. 5 cm) (100. 0 cm) LOCATION REQUIREMENTS To ensure proper ventilation for your refrigerator, allow for a 1/2" (1. 25 cm) space on each side and at the top. If your refrigerator has an ice maker, make sure you leave some extra space at the back for the water line connections. ¹/" (1. 25 cm) If you are installing your refrigerator next to a fixed wall, leave 33/4" (9. 5 cm) minimum on the hinge side (depending on your model) to allow for the door to swing open. NOTE: It is recommended that you do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C). 3³/" (9. 5 cm) Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. [. . . ] NOTE: It is recommended that you do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C). 3³/" (9. 5 cm) Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. [. . . ]