User manual WACOM CINTIQ 18SX

[. . . ] INTERACTIVE PEN DISPLAY INSTALLATION GUIDE AND USER'S MANUAL As an Energy Star© partner, Wacom Company Ltd. has determined that this product meets the Energy Star© guidelines for energy efficiency. No part of this manual may be reproduced except for your express personal use. Wacom reserves the right to revise this publication without obligation to provide notification of such changes. [. . . ] See Optional Display Configurations on page 53 for more information. 28 Removing Cintiq from the Display Stand To remove Cintiq from the display stand: s s If the lock brackets are attached, remove them from the back of Cintiq. Position the display to landscape orientation before removing Cintiq from the display stand. Firmly grasp the Interactive Pen Display on both the left and right sides of the body casing, and lift the unit out of the display stand bearing recess. Important: When removing Cintiq from the display stand, always lift Cintiq in a direction parallel to the front of the stand. s s Note: When packing Cintiq for transport, always pack the Interactive Pen Display and Cintiq stand in their original containers and protective cushions. Never pack the two items with the display unit mounted on the stand; this may damage the display unit or stand during transportation. 29 Using the Grip Pen WORKING WITH THE GRIP PEN (UP-911E) As you work with Cintiq, you can rest your hand on the display screen, just as if it were a drawing board or sheet of paper. Make sure the side switch is in a convenient location where you can press it with your thumb or forefinger, but won't accidentally press it while drawing. Eraser DuoSwitch (side switch) Tip switch Note: The Grip Pen should never be stored in a container where it will rest on its tip or eraser. When the pen is not in use, place your pen in the pen stand or lay it flat on your desk. Pen Tip The pen is activated as soon as it enters proximity, about 5 mm (0. 2 in), above the Interactive Pen Display screen. This allows you to position the screen cursor or use the DuoSwitch without touching the pen tip to the display screen. When pressure is applied to the pen tip, the tip switch is turned on and the pen simulates a mouse button click. The tip click pressure can be adjusted in the Wacom Tablet Control Panel. Please refer to the online Help for details. Eraser To use the eraser, hold the Grip Pen upside down. When the eraser is within proximity of the active area, the tablet reports the pen coordinates and the pressure applied to the eraser. The eraser can be used as an eraser or assigned to another function, depending on the application. Refer to the online Help for the pen settings. DuoSwitch The DuoSwitch is programmable, and can be used to perform the same click and double-click functions as the tip switch. Toggle the DuoSwitch in either direction to activate the upper or lower button functions. Please refer to the online Help for more information on switch settings. Note: If you do not care to use the side switch, you can remove it by following the directions in DuoSwitch Removal and Installation, on page 51. 30 USING A PEN Pointing and Selecting Move the Grip Pen above the Cintiq display screen to position the screen cursor. The cursor jumps to the location where you place the pen (absolute positioning). Press the pen tip on the display screen to make a selection. Note: If the screen cursor does not closely follow the pen tip, you will need to calibrate the Interactive Pen Display. (See Calibrating Cintiq on page 36. ) If the screen cursor does not jump to a position close to the pen tip when you place the pen on the display screen, then the tablet driver did not load yet. (See Learning More About Cintiq on page 37 for information on accessing the online Help. ) Clicking Tap the display screen once with the pen tip, or touch the pen to the display screen with enough pressure to generate a mouse click. Double-Clicking Press the upper side switch (Windows) or lower side switch (Macintosh), or quickly tap the display screen twice in the same place with the pen tip. Double-clicking is easier when the pen is perpendicular to the tablet screen. Tip: You can make navigating with the pen easier by configuring Windows to select when the pen is over an icon and to launch the icon with a single click. Open a folder, select the Tools pull-down menu, and Folder Options. . . . From the General tab select the option Single-click to open an item (point to select). [. . . ] Using a 3rd party ADC to DVI-D adaptor requires the use of this adaptor as a secondary adaptor for the Cintiq 18SX Interactive Pen Display. Accessories Extra pen tip: Pen stand: PSI-A007 PST-A026-03 57 WARRANTY Limited Warranty for Products Purchased and Used in U. S. and Canada WACOM warrants the product, except for the Software, to be free from defects in materials and workmanship under normal use and service as long as the product remains in possession of the original owner, for a period of two (2) years, as evidenced by a copy of the receipt and a registration card that has been returned to WACOM within 30 days of purchase. The Software is licensed "as is. " WACOM makes no warranty with respect to its quality or performance. WACOM cannot guarantee you uninterrupted service or the correction of any errors. [. . . ]