User manual VIVANCO RF-HEADPHONE SET WITH CHARGING STATION

[. . . ] This wireless headphone system operates using the latest transmission technology. Enjoy your favourite music or films in top quality stereo sound without inconvenient cable connections. A Transmitter 1 Charging indicator light 2 Operation indicator light 3 Channel selection switch 4 Audio connecting cable 5 AC adaptor connector 6 AC adaptor 7 RCA adaptor 8 Jack adaptor 3. [. . . ] Do not dispose of this product with the domestic waste; take it to your local electronic waste recycling depot. To open the battery compartment, carefully pull off the ear cushion from the left side earshell "L". Insert the batteries or rechargeable batteries (micro, type AAA) into the battery compartment, observing the correct polarity. Place the ear cushion over the battery compartment again and press it carefully until it latches. Place the transmitter near to your hi-fi system, your TV or another audio source. Connect the AC adaptor to the connector on the transmitter, then plug it into a mains socket. Charging of the rechargeable batteries starts automatically and the charging indicator light of the charging tray switches to red. If the charge indicator doesn't change to red, move the handset back and forth slightly in the charging shell until the charging contacts snap into place correctly and the charge indicator changes to red. Note: Before the first use, charge the rechargeable batteries continuously for 15 hours in order to obtain the full capacity. Problem No transmission / no sound Possible cause Devices are outside range Batteries are empty Connection cut off Incoming signal not loud enough Interference on channel Batteries are almost empty Devices are on outer margin of range Position of transmitter No charging - the charging display doesn't switch onto loading (red LED) Headphones don't stand on the charger optimally Check whether or not all plugs are correctly plugged in. In some cases it may be necessary to place the transmitter somewhere else or higher. Check whether the side of the headphones marked with " L " show to the left. Move the headphones then into the charger carefully back and forward until the charging connections lock correctly and the charging display switches to red. Interference can be heard during transmission Using different batteries The RF headphone can also be used with other chargeable standard AAA micro batteries or non-chargeable 1. [. . . ] Vrid ljudstyrkan för ljudkällan till ca 1/4-1/3 av den totala ljudstyrkan Om laddningsindikeringen inte kopplar om till rött: Flytta luren försiktig fram och tillbaka i laddskålen ända tills laddningskontakterna faller in i rasterspåret och laddningsindikeringen kopplar om till rött. Om laddningsindikeringen inte kopplar om till rött: Flytta luren försiktig fram och tillbaka i laddskålen ända tills laddningskontakterna faller in i rasterspåret och laddningsindikeringen kopplar om till rött. Flytta sedan hörlurarna lätt fram och tillbaka i laddningsfacket till dess att laddningskontakterna går i ingrepp på rätt sätt och laddningsindikatorn slår om till rött. [. . . ]