User manual VIVANCO 2 IN 1 TVDVB UNIVERSAL REMOTE CONTROL

[. . . ] Check that the polarity markings on the batteries and in the battery compartment are correctly lined up (+=+), then close the flap carefully. 2 Adapting to appliances In order to control your appliances you must adapt or set the remote control to them. [. . . ] 3 3rd number of code (ones = Volume+): Press the VOL+ (volume up) button once for the 1 of 241. If incorrect entries are made the remote control blinks for about 3 seconds. When your appliance reacts, very quickly press the Mute button to confirm a functioning control code. ­ It is advisable to have your finger already placed on the Mute button so that you can react quickly enough. Otherwise the UR Zap 2 II emits the next signal before you have reacted. 6 Finally, test the control code setting by trying to control your DVB (SAT, CBL) appliance. 3 Code Identification You can identify the codes you have set at any time: 1 Select the appliance to be controlled using the TV or DVB (SAT, by trying to control (in this example) your CBL) button. 2 Keep the On/Off PWR and Mute not correctly try a different code from the list or code search (see below). 2 Code search press Ch+ briefly and count the If the brand of your appliance is not in number of times the ten blinks and the list or none of the codes given fits, finally, press Vol briefly the number of we recommend a code search. For channel number, for example, appears in quick code entry after replacing the the display of your DVB (SAT, CBL)ellite batteries. [. . . ] Scan: When you press this button a channel-up signal CH+ is emitted every 1, 3 seconds and the following channels are shown one after the other without your having to press a button repeatedly. This function stops when you press any button and ends automatically after 2 minutes. [. . . ]