User manual ULTIMATE SPEED UPA 500 A1

[. . . ] TAKE NOTE A warning at this risk level signifies potential property damage. Pay heed to the instructions in this warning to avoid property damage. NOTICE A notice signifies additional information that can assist you in the operation of the appliance. This appliance is intended exclusively for the signaling of distances between a vehicle and the garage wall and thus facilitates the process of parking. [. . . ] Special caution should be shown when handling damaged or leaking batteries. If you do not intend to use the appliance for an extended period, remove the batteries. Slide the battery compartment cover in the direction of the arrow and remove it from the appliance. Pay heed the the polarity markings given in the battery compartment 6 . NOTICE If, during use or in standby mode, the red LED 3 flashes once every 10 seconds, the batteries are too weak and must be replaced. DANGER When drilling the holes ensure that any electric cables or other installations in the wall, such as water pipes, are not damaged. tAKE NOTE The supplied plugs are only suitable for a mounting on concrete or stone. Before starting the installation, please check your installation location carefully for its suitability for the plugs. On the garage wall at the level of Attach the Parking Lamp the windshield of your vehicle. Attach the ultrasonic sensor on the garage wall at the level of the bumper of your vehicle. Now bore, using an electric or hand drill fitted with a 6 mm drill, the four holes to a minimum depth of 30 mm. NOTICE Alternatively, you can also use the supplied hook and loop and the ultrasonic pads for mounting the Parking Lamp sensor 7 . The appliance has three operating modes: Standby The appliance switches automatically into standby mode (energy saving mode) if no movement has occurred within the monitoring area for about 30 seconds. in the case of movement occuring , the appliance automatically detects the entrance or exit , and switches itself on again. Entrance On entrance into the garage the appliance switches itself on with the light sequence green - yellow - red. Exit Should a vehicle remove itself from close to the appliance, the yellow LED 4 switches on and then the green LED 5 . The appliance is now operational and the green LED 5 glows permanently. Now test the functionality by moving slowly towards the ultrasonic sensor 7 and checking the individual light signals of the Parking Lamp . [. . . ] The complete original declaration of conformity can be obtained from the importer. You receive a 3-year warranty for this appliance as of the purchase date. This appliance has been manufactured with care and meticulously examined before delivery. In the case of a warranty claim, please make contact by telephone with our service department. [. . . ]