User manual ULTIMATE SPEED ULG 3.8 A1 BATTERY CHARGER

[. . . ] Disconnect the battery charger from the mains before you make or break the connections to the battery. - First connect the clamp that is not connected to vehicle bodywork, then connect the other clamp to the vehicle bodywork at a point away from the battery and the fuel line. Then disconnect the clamp attached to the vehicle bodywork before you disconnect the clamp from the battery. Ensure that there is complete protection from moisture at the connections to the battery and at the mains outlet socket! [. . . ] In a vehicle, first disconnect the minus pole connecting cable (black) of the vehicle from the minus pole of the battery. Then disconect the plus pole connecting cable (red) of the vehicle from the plus pole of the battery. Connect the mains lead 11 of the battery charger to an electrical power outlet socket. This appliance has been designed for charging a variety of SLA batteries (sealed lead acid batteries), as mainly used in cars, motorbikes and several other vehicles. A special design of the appliance (also named , , three-phase-charging strategy") enables the recharging of the batttery to almost 100 % of its original capacity. Connecting the battery for a long period to the battery charger is also a good way of ensuring that your battery is kept in optimum condition. Before you carry out any work on the battery charger always pull the mains plug out of the mains socket. Ensure that you do not strike electrical cables, gas or water pipes when you are drilling into the wall. If necessary, check the wall using a suitable detector before you drill. You may find it convenient to attach the battery charger on to a board or a wall. Screw the two screws through the mounting holes 12 into the board or wall. You can select different charging modes for charging different batteries at different ambient temperatures. In comparison with conventional battery charging stations, this appliance has a special function for reusing an empty battery or rechargeable battery. Safe charging is ensured by means of a protection function against incorrect connection and short circuiting. Due to the installed electronics, the charging station does not begin operation directly after connecting the battery, but only starts after a charging mode has been selected. After connection to the power supply, the appliance automatically returns to its basic setting and remains in STANDBY mode This mode is suitable for charging 12 V lead-acid batteries with a capacity less than 14 Ah. Appropriate LED indicator Then if you do not take any further action, the 8 electronic control and the LED indicator automatically switches on and starts the charging process. If the procedure runs without any 8 remains on problems, the LED display during the entire charging process, until the battery is fully charged. When the battery is 7 lights up and fully charged, LED display 8 goes out. The device now LED display switches automatically into maintenance charging mode. The device switches between charging modes in the following order: Standby , MODE 1 , , 6 V", MODE 2 , MODE 3 , MODE 4 and then repeats the cycle NOTE: If you press the selector button 9 , charging mode automatically switches over to the next mode and begins operation in that mode. NOTE: However, if a battery is not disconnected from the charging station after a full charge, the appliance remains in trickle-charge mode, even if the user switches over to another mode. [. . . ] Se till att anslutningen till batteriet och strömförsörjningens uttag är helt skyddade för fukt. Risk för personskador och / eller risk för skadad laddare föreligger. om laddaren ska anslutas till ett fast monterat batteri ska du läsa i fordonets bruksanvisning om hur elsäkerheten ska uppehållas och batteriet underhållas innan du ansluter laddaren!Risk för personskador och / eller risk för skadad laddare föreligger. [. . . ]