User manual TREK BIKES SENSOR 2.0

[. . . ] Setting the wheel circumference (100mm-2999mm) Sensor 2. 0 has 2 wheel circumference settings. The display shows 1/2155 and the last two digits "55" will flash. Advance them rapidly by holding down the R button, or one at a time by pressing the R button ( or go backward by holding the L button). 1 or Table 1 and between 100mm-2999mm) has been achieved, press both L & R buttons for confirmation and the next two digits will flash. [. . . ] Setting clock time Under any display mode except Stopwatch, press R button for 1 second. Repress either L or R button to return to "Odometer (ODO)" mode. Follow step 2 to complete setting clock time and 12/24 hour alternate. Remove the screw from the magnet and install it on one of the feasible spokes opposite the wheel sensor. Mount the wheel sensor on the fork blade opposite the magnet using the zip tie provided. 12/24 hours alternative. When clock is displayed, press both L & R buttons at the same time. Clock will blink then press L or R button to switch between 12 hours and 24 hours. To reset clock, press L & R at the same time ( as following b. ); after 3 seconds, clock will stop blinking automatically. After choosing 12 or 24 hours, press L & R at the same time, minutes "MM" will blink (fig. Advance them rapidly by holding the R button, or one at a time by pressing the R button (to go backward hold or press the L button). Follow the same method to adjust hour "HH" to complete the whole setting. Press R button to move to other display modes after clock is set. fig 5 b. Lift the front wheel off the ground and spin the wheel checking if current speed is displayed. If not, adjust positions of wheel magnet and fork sensor as described in installation steps 7-8. Refer to the following steps for the operation of your sensor computer. Installation 1. Use the attached rubber pad between the bracket and handlebar to provide a secure fit. Slide the zip tie into bracket, position the bracket to the handlebar on either side or the stem. Cut the excess zip tie off. Page 4 Page 5 Display Functions Speed Minimal display unit 0-30km/h 0. 1km/h(mile/h) 31-60km/h 0. 5km/h(mile/h) over 60 m/h 1km/h(mile/h) Riding time ( 0:00:00-99:59:59) -- RT The Elapsed Time is measured from the start point to the current point. It starts counting automatically when signals are received, it stops when signals have stopped for over two seconds. When 10 hours have been reached, screen will display "HH" hr & "MM:SS" alternative for 1 second. Average Speed (AVS), Distance (DIS) and Maximum Speed (MAX) will also reset and recount from Zero. Current Speed (0. 0-70 miles or 99 kms)-S The current speed is displayed on the upper line of display and updated every second. Minimum display unit will be automatically adjusted according to speed. Odometer (total Distance) (0. 0-9999 kms or 6213 miles)-ODO The total distance is continuously measured, accumulated and displayed until next reset or the battery is changed. [. . . ] (3V/DC) Is there anything on the Wipe the contact clean contact of the main unit or on the bracket?8" and re-adjust correctly. Auto Scan Under any display mode, press the L button to enter the auto scan function. All display modes will cycle with each display mode lasting 3 seconds. Press L or R button to return to the current display mode in use. Auto Power Saving In any display mode, the unit will go into power-save mode after the computer has not received any input signal for 10 minutes. [. . . ]