User manual TNB HPMU036198

[. . . ] To reduce the risk of fire, explosion, electric shock, or personal injury when using your hob, follow these basic safety precaution Do NOT attempt. Note Important 2_ using this manual HPMU036198_XSA_00338A-EN. indd 2 2011-01-19 4:08:45 safety instructions The safety aspects of this appliance comply with all accepted technical and safety standards. However, as manufacturers we also believe it is our responsibility to familiarize you with the following safety instructions. SAFETY INSTRUCTIONS WARNING ELECTRICAL SAFETY Be sure the appliance is properly installed and grounded by a qualified technician. Repairs carried out by unqualified individuals may cause injury or serious malfunction. [. . . ] This appliance complies with the following EU Directives: · 2006/95/EC, Low Voltage Directive · 2004/108/EEC, Electromagnetic Compatibility Directive SAFETY INSTRUCTIONS FOR THE INSTALLER · A device must be provided in the electrical installation that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm. Suitable isolation devices include line protecting cut - outs, fuses (screw type fuses are to be removed from the holder), earth leakage trips and contactors. With respect to fire protection, this appliance corresponds to EN 60335 - 2 - 6. This type of appliance may be installed with a high cupboard or wall on one side. The kitchen unit in which the appliance is fitted must satisfy the stability requirements of DIN 68930. For protection against moisture, all cut surfaces are to be sealed with a suitable sealant. On tiled work surfaces, the joints in the area where the hob sits must be completely filled with grout. On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place with a suitable artificial resin or mixed adhesive. Ensure that the seal is correctly seated against the work surface without any gaps. Additional silicon sealant must not be applied; this would make removal more difficult when servicing. The surface temperature on the underside of the electric hob may exceeds 95°C. This provides the appliance with a cooking zone of variable size, for instance, for when cooking with smaller cookware. Multipurpose cooking zone: The hob is equipped with a multipurpose / casserole cooking zone. Depending on the setting, it can be used as a round or oval cooking zone, for example, for when cooking with oval casseroles or for keeping dishes or food warm. Digital displays: The four display fields are assigned to the four cooking zones. They show the following information: the appliance has been switched on, to selected heat settings, residual heat, the child lock is activated error message, the sensor has been touched for longer than 10 seconds. error message, when the hob is overheated because of abnormal operation. (example : operation with empty cookware) · parts and features _17 HPMU036198_XSA_00338A-EN. indd 17 2011-01-19 4:08:47 SAFETY SHUTOFF If one of the cooking zones is not switched off or the heat setting is not adjusted after an extended period of time, that particular cooking zone will automatically switch itself off. (for "hot") in the digital displays Any residual warmth will be indicated with corresponding to the particular cooking zones. The cooking zones switch themselves off at the following times. Heat setting 1-2 3-4 5-6 7-9 Switch off After 6 hours After 5 hours After 3 hours After 1 hours If the Hob is overheated because of abnormal operation, And the Hob will be switched off. will be displayed. Should one or more of the cooking zones switch off before the indicated time has elapsed, see the section "Troubleshooting". Other reasons why a cooking zone will switch itself off All cooking zones will immediately switch themselves off if liquid boils over and lands on the control panel. The automatic shutoff will also be activated if you place a damp cloth on the control panel. In both of these instances, the appliance will need to be switched sensor after the liquid or the cloth on again using the main On/Off control has been removed. RESIDUAL HEAT INDICATOR When an individual cooking zone or the hob is turned off, the presence of residual heat is (for "hot") in the digital display of the appropriate cooking zones. [. . . ] Wipe and rub dry. TO AVOID DAMAGING YOUR APPLIANCE · · · Do not use the hob as a work surface or for storage. Do not operate a cooking zone if there is no pan on the hob or if the pan is empty. Ceramic glass is very tough and resistant to temperature shock, but it is not unbreakable. It can be damaged by a particularly sharp or hard object dropping onto the hob. [. . . ]