User manual THOMSON VS 990

[. . . ] The Video Sender eliminates all the problems of long cables or forcing you to keep your screen close by. The receiver is installed next to the flat screen while the other appliances remain in their cabinet alongside the transmitter in another part of the room or even in another room. Diagram B ­ you can use a second TV set or flat panel screen in a room that has no antenna outlet or doesn't have the same appliances you have in your main set-up thanks to the Video Sender. If your main gear is in the lounge, for example, then you can see pictures in the other room from one of these appliances by installing the transmitter in the lounge and the receiver close to the second TV set. [. . . ] Usually, this will be a more or less large, transparent area located on the front of the unit. Remove the protective self-adhesive film from the infrared cell of cord (6) and affix it to the infrared-sensitive panel of the equipment to be remote controlled. The cordon has 3 cells in order to let you play video and audio from 3 equipment items connected to the (TV1) set (see separate document or at the end of this booklet). This range will be less inside a building depending on the wall and floor materials, etc. See the installation diagrams (B and C) inside the cover at the beginning of the instruction booklet Place the receiver (1) on, or near, the second television set (TV2). Fit the AC adaptator (3) to the receiver and plug it into a 220/240 V ~ 50 Hz mains power supply. See the installation diagrams (B and D) inside the cover at the beginning of the instruction booklet Place the transmitter (4) near the source equipment (VCR player, DVD player, etc. ) from which you want to transmit video or audio output, and connect it with the cord (5). Connect the TV set to a suitable outlet from the VCR player or DVD player (AV1). Obtain a (non-supplied) SCART-TV set connector and connect the TV set to the (5) adapter already connected to the VCR player or DVD player (see item marked *) For successful audio/video transmission, the transmitter (4) and receiver (1) must be set to the use same transmission channel. An indicator light blinks on each control box while the channel is being sought and stops blinking when the transmitter and receiver are synchronised. Using the remote control of the unit whose pictures you wish to see, and from the room containing the second television set (TV2), select the channels or video functions (or others) according to the unit you are controlling. Television set by selecting those of the video recorder with its remote control. The running of certain equipment (micro-wave ovens, digital telephone DECT, un-shielded acoustic loudspeakers, etc . Ensure that they are kept away from the transmitter and the receiver or switch them off. Improvement of picture and sound If no picture is obtained, check that the transmitter and the receiver have not been installed in the reverse order (each unit corresponds either to the input or to the output of the Audio-Video signal). Check that they have been properly connected and that they are switched on (on position). Note: This product is designed and manufactured with high quality materials and components which can be recycled and reused. [. . . ] also , refer to the manufacturers' instructions to see if there are any particularities regarding connection or use. Certain units may need to have their input scart connection "programmed". It is essential that you switch off all unused equipment (put them on standby). Vous pourrez même commander, depuis la pièce du second téléviseur, l'appareil dont vous visionnez les images, avec sa télécommande comme si il se trouvait effectivement dans la pièce. [. . . ]