User manual THOMSON VS 650

[. . . ] connection to a public or independent network , or to an outside aerial is prohibited. Under no circumstances should this appliance be put to industrial use. THOMSON multimedia disclaims all responsibility in the event of use that does not comply with the present instructions. The Video Sender VS 650 permits the relay of an Audio-Video signal from your main set-up to a second television set located in another room and equipped with a scart connection (or RCA/Cinch). [. . . ] Remove the protective self-adhesive film from the infrared cell of cord (4) and affix it to the infrared-sensitive panel of the equipment to be remote controlled. The cordon has 3 cells in order to let you play video and audio from 3 equipment items connected to the (TV1) set (see Diagram on Page 10). Fit the mains supply lead (3) to the transmitter and plug it into a 220/240 V ~ 50 Hz mains power supply. Connect the receiver (5) to the second television set using the lead (6) following the same instructions as for the transmitter. Fit the mains supply lead (7) to the receiver and plug it into a 220/240 V ~ 50 Hz mains power supply. THE ANTENNA allows you to transmit and receive audio and video signals over a maximum range of 30 meters in free air environments. Inside a typical lodgment the range will be less because of signal attenuation by building material absorption. THE TELESCOPIC AERIAL permits the control of the unit whose pictures you wish to see in the room containing the second television set (TV2). Make sure that the transmitter and the receiver are set to the same channel by checking the position of the selectors located under the casing. Using the remote control of the unit whose pictures you wish to see, and from the room containing the second television set (TV2), select the channels or video functions (or others) according to the unit you are controlling. Make sure that you point the remote control directly at the receiver's (5) infrared window. If you fail to obtain the desired picture on the second television set TV2, select the AV socket, to which the receiver (5) is connected, using the television's remote control. To have clear images on your second TV set (TV2), output from the decoder must pass through a VCR player, placed in (AV2) mode or set to the channel number assigned for the encrypted TV channel. If your second television set does not have a connection for an outside aerial (terrestrial reception), or if it is a monitor, you will be able to see the channels in the room containing the second television set by selecting those of the video recorder with its remote control. The running of certain equipment (micro-wave ovens, digital telephone DECT, un-shielded acoustic loudspeakers, etc . Ensure that they are kept away from the transmitter and the receiver or switch them off. Improvement of picture and sound You will obtain optimal service operation of your Video Sender by correctly orienting the antennae (A). However, reflected signals or other signal degrading factors can affect good quality signal transmission. In this case, readjust antennae positions or slightly move the transmitter or receiver until you get crystal clear reception. If no picture is obtained, check that the transmitter and the receiver have not been installed in the reverse order (each unit corresponds either to the input or to the output of the Audio-Video signal). [. . . ] These diagrams show a few connection possibilities whose operation depends on the devices you have, their sockets and the signals they deliver. There are therefore other connection setups that you may need to try if the setup shown does not meet your requirements. In that case, ask your reseller for assistance or contact our customer service (Helpline). You can contact THOMSON by dialing: 0845 601 3093 (For Great-Britain, all calls will be charged at local rate) www. [. . . ]