User manual THOMSON ROC Z407 CODE

[. . . ] Example: if you want to control a satellite receiver with the AUX key, begin by entering a satellite code (any satellite code that you find in the code list, for example: 603 for a Thomson satellite receiver) then begin the automatic search procedure. the remote control will then test all the satellite codes for the selected make. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 4. [. . . ] Press the key (15) that corresponds to the type of equipment you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver, DVD: DVD player, AUX: other set 4. While the indicator is lit, enter the first digit of the 3-digit code proposed for the set to be controlled (example: 036 for Thomson). Direct the remote control towards the set and try to switch it off by pressing the key B (17). Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 4. Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. Hold down the S (6) key until the key that corresponds to the last mode you selected blinks 3 times and then remains lit. Press the key (15) that corresponds to the type of equipment you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver, DVD: DVD player, AUX: other set 4. Direct the remote control towards the set and try to switch it off by pressing the key B (17). If the set you want to control switches off, press OK (2) to memorise the subcode. Should the set not switch off, press key B (17) as many times as required (up to 200 times), until the set switches off. Hold down the S (6) key until the key that corresponds to the last mode you selected blinks 3 times and then remains lit. Press the VCR (15) key, then follow one of the programming methods (A, B, C or D) described earlier. Hold down the S (6) key until the key that corresponds to the last mode you selected blinks 3 times and then remains lit. Press the key (15) that corresponds to the type of equipment you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver, DVD: DVD player, AUX: other set 3. Press the numbered keys in ascending order (0 to 9) until the selected mode blinks once. The number that caused the selected mode to blink is the first of the three numbers that make up your code. When the third number has been found, the indicator light for the selected mode goes out. - For a television or a satellite receiver: switch on and, for example, press 2 to change channels. Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, try the programming Method B or C. When you have retrieved the code of your set, jot it down so that you can use it whenever needed. [. . . ] Since some satellite and cable receivers have no volume control, the ROC Z407 remote control allows you to control the television's volume in satellite or cable mode. For satellite systems with a volume control, it is possible to choose the set that the MUTE (21) and VOL (19) keys will control in each of these modes: the television volume or the volume of the satellite or cable receiver. Press the TV key (the remote control must be in TV mode for this procedure). Hold down the S (6) key until the last mode selected (TV) blinks 3 times and then remains lit. [. . . ]