User manual THOMSON ROC 6505

[. . . ] ENGLISH - Do not mix different types of batteries or new and old batteries. In order to avoid any risk of explosion, observe polarities indicated inside the battery compartment. If you are not using the remote control for a long period of time, remove the batteries. Before you dispose of batteries or accumulators, ask your dealer whether they are subject to special recycling and if they will accept them for disposal. [. . . ] The blinking of the indicator indicates the end of the available time, then it goes out). Press the numbered keys in ascending order (0 to 9) until the selected mode blinks once. The number that caused the selected mode to blink is the first of the three numbers that make up your code. When the third number has been found, the indicator light for the selected mode goes out. Press the key corresponding to the type of equipment (for example TV). After a few seconds the remote control begins to list all the codes included in the library (around 1 a second code per second). Press PROG time to reduce the speed of the test (1 code every 5 seconds). As soon as the device changes channel you must immediately press OK to record the code and stop the listing. If you don't react quickly enough, simply return to (you the previous code by pressing PROG can restart the forward listing by pressing PROG . For a television or a satellite receiver: switch on and, for example, press 2 to change channels. Video recorder: load a tape and then press · DVD player: load a DVD and then press . ) and the make, you will be required to enter a single code for both devices in the COMBO, or to enter two codes, one code per device. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder). Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit. Press the key of the first device to control, and then follow one of the programming methods A, B, C or D previously described. Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, try the programming Method B or C. When you have retrieved the code of your set, jot it down so that you can use it whenever needed. The MACRO key in coordination with one of the keys A, B, or C allows the programming and memorisation of up to 3 command sequences (the automatic and successive pressing of several keys of your choice). Thus any sequence of key commands can be reduced to merely 2 commands (MACRO key + A, B, or C key). For example after programming, by pressing MACRO then key A you could turn on your television set, turn on your satellite or cable receiver, zap to a preferred channel, turn on your video cassette recorder and start a recording session (providing a cassette was previously loaded). If a second code programming is required, then repeat steps 2 and 3 above. [. . . ] Placing all devices on standby Press the key twice in less than one second, keeping it held down the second time. You can allocate the volume control to one of the modes of the remote control on condition that the volume control exists on the corresponding device (e. Hold down the SETUP key until the key corresponding to the last selected mode remains lit. ) corresponding to the device whose volume will always be controlled by the VOL and keys. [. . . ]