User manual THOMSON ROC 56

[. . . ] F (FF) : fast forward for VCRS and DVDS; press with blue key for fast text function in TV mode. B (PLAY): plays a VCR tape or DVD disk; press with yellow key for fast text function in TV mode. K (PAUSE): Suspends play and stops on an image; press with magenta key for fast text function in TV mode. i/EXIT: Teletext Off in TV mode; turns off the menu of the selected product (SHIFT + EXIT). [. . . ] Point the remote control towards the product and try to turn it off by pressing the B key (11). If the product doesn't turn off, repeat step 2, using the next 3-digit code in the list. Checking the programming: Your product should be ready to receive remote control commands. If none of the codes work, you may still be able to retrieve the appropriate code. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the product key (2) that corresponds to the type of product you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver, DVD: DVD player, AUX: other product. Point the remote control towards the product and try to turn it off by pressing the B key (11). If the product you want to control turns off, press OK (8) to save the subcode. If the product does not turn off, press the B key (11) until the product switches off (up to 200 times). Wait approximately one second between key presses to give the red indicator lamp (1) enough time to go off and light up again. Immediately upon turning off the product to be controlled, press OK (8) to save the code. Note: When programming the AUX key (to control any type of product) begin by entering a code that corresponds to the product you want to programme (a 3-digit code that you will find in the code booklet ­ see method B). Example: if you want to control a satellite receiver with the AUX key, begin by entering a satellite code (any satellite, for example: 603 for a Thomson satellite receiver) then begin the procedure. Checking the programming: Your product should be ready to receive remote control commands. With this method, the remote scrolls through the full code list by sending an IR signal to the product to be controlled remotely. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the product key (2) corresponding to the type of product you want to control: (for example TV). After a few seconds, the remote begins to scroll through the code list at approximately 1 code per second. [. . . ] For satellite systems with a volume control, you can choose the product that the (8) and VOL (7) keys will control: the television volume or the volume of the satellite or cable receiver. Press the TV key (2) (the remote control must be in TV mode for this procedure). Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). [. . . ]