User manual THOMSON ROC 4406

[. . . ] PROG+/-: Programmes zapping button (rapid select); use to scroll vertically through menus (SHIFT + PROG+/-). s/SHIFT: Programmes the remote control (S) or activates the secondary key features (SHIFT). 3: Press this key first before you type in the 2-digit channel number (except for Thomson group products). Press the product key (2) that corresponds to the type of product you want to control: TV: television set DVD: DVD player VCR: video recorder AUX: other product SAT: satellite receiver 3. [. . . ] Note: When programming the AUX key (to control any other type entering the code that corresponds to the product you want to code that you will find in the code booklet ­ see method B). Example: if you want to control a satellite receiver with the AUX a satellite code (any satellite, for example: 603 for a Thomson begin the procedure. Of product) begin by programme (a 3-digit key, begin by entering satellite receiver) then Checking the programming: Your product should be ready to receive remote control commands. Before you start programming, you must find the code for the product to be controlled (Television, VCR, satellite receiver, cable receiver or DVD player). Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the product key (2) that corresponds to the type of product you want to control: TV: television set, VCR: video recorder, SAT: satellite receiver, DVD: DVD player, AUX: other product. While the indicator is lit, enter the 3-digit code proposed for the product to be controlled (example: 036 for THOMSON). The red indicator then goes off if the code is correct or flashes, if the code is not on the list. Point the remote control towards the product and try to turn it off by pressing the B key (11). If the product doesn't turn off, repeat step 2, using the next 3-digit code in the list. Example: if you want to control a satellite receiver with the AUX key, begin by entering a satellite code (any satellite, for example: 603 for a Thomson satellite receiver) then begin the procedure. Checking the programming: Your product should be ready to receive remote control commands. To set up the remote control to control a COMBO you first programme the television and then the video recorder subset. Before you start programming, you must find the subcode or code of the combo to be controlled (television or video recorder). Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the TV key (2), then follow one of the programming methods (A, B, C or D) described earlier. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the VCR key (2), then follow one of the programming methods (A, B, C or D) described earlier. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. [. . . ] Press the TV key (2) (the remote control must be in TV mode for this procedure). Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). The indicator light will blink and then go off for about 8 seconds before blinking once more and then staying off. [. . . ]