User manual THOMSON ROC 4207 CODE

[. . . ] When videotext is active, these coloured keys can be used to select headings, depending on the set's make. Indicator lamp: the red indicator lamp lights up when any key is pressed. Number keys 0 to 9: these keys have the same functions as those of your original remote control and are used to enter the codes of your different sets. Direct the remote control towards the TV set and try to switch it off by simply pressing the key B (1). [. . . ] Should the set not switch off, you'll have to programme the remote control by means of one of the methods A, B, C or D described hereinafter in chapter 3. This Universal Remote Control is compatible with most models of infrared-controlled TV sets, video recorders, LVD players, satellite and cable TV receivers. Before you start programming, you must find the subcode of the set to be controlled (television set, video recorder or satellite receiver). Hold down the key SET UP (17) until the red indicator lamp (13) remains lit (the indicator lamp remains on for a couple of seconds, so that you have time enough to proceed with steps 4 to 6. The indicator lamp flashes to signal that this time is almost up, and then goes off). Direct the remote control towards the set and try to switch it off by pressing the key B (1). Should the set not switch off, press key B (1) repeatedly, until the set switches off. Between two subsequent key depressions, give the red indicator lamp (13) enough time to extinguish and light up again (about 1 second). Proceeding this way will enable you to see whether the set responds or not. Check of the programming In principle, your set is ready for receiving the remote control commands. Try out other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, repeat the procedure of this programming method to find out the code supporting a wider range of features. Setting up the remote control for control of a COMBO means that you first programme the television and then the video recorder subset, the combination of which makes up the COMBO set. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder). Set the remote control selector (26) on TV, and then proceed with one of the programming methods A, B or C described above. Set the remote control selector (26) on VCR, and then proceed with one of the programming methods A, B or C described above. Hold down the key SET UP (17) until the red indicator lamp (13) remains lit. Press the number keys (0 to 9) in ascending order until the red indicator lamp (13) flashes once. The digit which made the red indicator lamp (13) flash, is the first number of the 3-digit code. - For a TV set or satellite receiver: press for instance number key 2 to switch over to another channel or to switch the set on, in case it is off. [. . . ] The digit which made the red indicator lamp (13) flash, is the first number of the 3-digit code. - For a TV set or satellite receiver: press for instance number key 2 to switch over to another channel or to switch the set on, in case it is off. Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, try the programming Method B or C. [. . . ]