User manual THOMSON ROC 2406

[. . . ] This remote control has been factory programmed to allow you to use it immediately with the majority of Thomson Group devices. If programming is necessary, follow one of the methods A, B, C or D that are given in this manual. Keep these instructions and the separate list of codes in a safe place so that you can later reprogram your remote control. Selects the connectors (AV) to which devices are going to be connected (TV source / video). [. . . ] Check your remote control for proper functioning by performing the test described on page 3. Try out other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, repeat the procedure of this programming method to find out the code supporting a wider range of features. With this method, the remote control scrolls through the full code list by sending an IR signal to the set to be controlled remotely. Press the key that corresponds to the type of equipment you want to control: TV: television set - DVD: DVD player - VCR: video cassette recorder - SAT: satellite / cable - AUDIO: Hifi system. Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit. Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit (the indicator lamp remains lit for several seconds in order to let you continue with the following steps. The blinking of the indicator indicates the end of the available time, then it goes out). Press the key corresponding to the type of equipment (for example TV). Press the numbered keys in ascending order (0 to 9) until the selected mode blinks once. The digit that makes the selected mode flash is the first of the 4 digits in your code. Press once the A, B, or C key which you are going to use to memorise the sequence. ) mode key of the first device you wish to control (the first key must always be a mode key. Successively press the keys corresponding to the commands you wish to send to the device(s) (9 keys maximum, including other mode keys). Note: a sequence will be automatically memorised after the tenth key press (counted from the mode key) and the mode key light will go out. If the make of the device you wish to control is not in the separate code list, you can copy the key functions of the original remote control of the device into your ROC 2406. Depending on the format of the transmission codes of the original remote control, your ROC 2406 remote control can memorise up to 150 keys Global delete ­ Delete all the keys copied (this is recommended the first time you use this function) Hold down the SETUP key until the key corresponding to the last selected mode remains lit. The batteries in the 2 remote controls must be in good condition; change them if necessary. Press the MACRO key once and, within 20 seconds, press the A, B, or C key you used to memorise the sequence. Lay out the original remote control and your ROC 2406 end to end so as to align the LED diodes on the 2 remote controls. Where necessary adjust the height of both remote controls so that the LED diodes are properly aligned. First copy 2 or 3 keys from the original remote control in order to check the compatibility of the codes of both remote controls. [. . . ] Press once on one of these keys (8) then once on the mode key (TV, DVD, VCR, . Press the key twice in less than one second, keeping it held down the second time. Hold down the SETUP key until the key corresponding to the last selected mode remains lit. notes: · During the programming of the HOME CINEMA, key, any action on the FAV, MACRO keys, or mode keys (TV, DVD, . [. . . ]