User manual THOMSON ROC 1407 CODE

[. . . ] Hold down the SETUP key until the red indicator lamp blinks and then remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). Press the key that corresponds to the type of equipment you want to control: TV: television set, DVD: DVD player, VCR: Video recorder, SAT/CABLE: satellite receiver, cable, DVBT, ADSL, AUDIO/AUX: audio equipment and any other appliance. Direct the remote control towards the set and try to switch it off by pressing the key G. [. . . ] Press the key that corresponds to the type of equipment you want to control: TV: television set, DVD: DVD player, VCR: Video recorder, SAT/CABLE: satellite receiver, cable, DVBT, ADSL, AUDIO/AUX: audio equipment and any other appliance. While the indicator is lit, enter the first digit of the 4-digit code proposed for the set to be controlled (example: 0166 for a Thomson TV). Direct the remote control towards the set and try to switch it off by pressing the key G. As soon as the set changes channels, you must press OK to save the code and stop the remote control scrolling through the list. If you do not react quickly enough, you can go back to the previous code by pressing Prog- or E (DVD/ VCR only) as many times as necessary (you can go forward by pressing G , Prog+ or B (DVD/ VCR only) if you have gone back too far). ) and the make, you will be required to enter a single code for both devices in the COMBO, or to enter two codes, one code per device. Before you start programming, you must find the subcode or code of the subset to be controlled (television or video recorder, . Hold the SETUP key down until the red indicator lamp blinks and then remains lit. Press the key of the first device to control, and then follow one of the programming methods A, B, C or D previously described. If a second code programming is required, then repeat steps 2 and 3 above. If the make of the device you wish to control is not in the separate code list or if some functions are missing in the code you have programmed, you can copy the key functions of the original remote control of the device into your ROC 1407. Method D ­ Automatic code search With this method, the remote control scrolls through the full code list by sending an IR signal to the set to be controlled remotely. Hold down the SETUP key until the red indicator lamp blinks and then remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). Press the key corresponding to the type of equipment (for example TV). After a few seconds, the remote control begins to scroll through the whole code list included in the library (at a rate of roughly 1 code per second). Note: Some original remote controls don't transmit continuous IR signals when a key is held down. If this is the case, press several times on one of the keys while moving the remote control from left to right. Press once on the key of your ROC 1407 to which you want to copy one of the keys of your original remote control. Hold down the key of the original remote control you wish to copy until the red indicator lamp goes out and then relights (2 to 3 seconds). In case of problems, the red indicator lamp will blink for 3 seconds but will remain in learning mode. Hold down the SETUP key until the red indicator lamp blinks and then remains lit. [. . . ] Hold the SETUP key down until the red indicator lamp blinks and then remains lit. The volume and mute functions are now restored to their factory defaults. Find/Page Feature The ROC 1407 comes with a convenient base/stand that you can place the remote in when you're not using it. The base/stand also has a Find/Page feature, which lets you quickly find the remote from up to 6 meters from the base, if you've misplaced it. [. . . ]