User manual THOMSON ITC008B+

[. . . ] Should you use it, in exceptional circumstances in the open air (example: on the balcony, in the veranda or tent), you must absolutely protect it against moisture (dew, rain, splash water). The appliance should not be in contact with liquids or exposed to the risk of dripping or splashing. Therefore be careful not to place any object containing a liquid (vase, glass, bottle, . . . ) on or near your appliance. Before switching on a cold TV set in a warm room, you should wait until any condensation in the screen has dried by itself. In the evening, after TV programmes or in case of a long absence, it is recommended to turn of the apparatus at the main switch. [. . . ] - Select the number of the character table, using the table on page 7. Subsequent set-ups: To proceed with a new Automatic Channels set-up, press the MENU key of the remote control : - twice for mono TVs, - three times for stereo TVs. With the On/Off-button fitted on the set. When the red LED is lit, the TV set has previously been switched on standby with the key B on the remote control. To switch the TV set on again, type in a channel number. Automatic Channel Set-up Initial set-up. · When a VCR or satellite receiver is connected to the aerial socket, you must switch on this equipment. Should external equipment be connected to the TV set via the SCART socket, it must be turned off. When you first switch on the TV the INSTALLATION menu appears and the Language option is highlighted. · Select the appropriate standard using the Left/Right buttons: EURO :Western Europe, Tunisia, Morocco, Australia, New Zealand. · Use the buttons Up/Down to then select the Start option and press ok to start the search. Two new lines appear showing the frequency and programme number on which each new channel found is memorised. Wait a few minutes until the ORGANISER menu appears. 4 ITC008B+_en 23/01/04 13:21 Page 5 Manual Channel Set-up 1. Display the INSTALLATION menu by pressing MENU on the remote control unit: - Twice for mono TV sets. Select the Manual option using the Up/Down buttons and press ok to display the MANUAL INSTALLATION menu. Select the appropriate standard using the Left/Right buttons: EURO :Western Europe, Tunisia, Morocco, Australia, New Zealand. Start the set-up in a decreasing or increasing order by means of the Left/Right directional keys. If the picture quality is poor, make use of the directional keys Up/Down to select the line -> . <- and try to improve picture quality with the directional keys Left/Right. . Then select the PR line through the Up/Down directional keys and enter the channel number corresponding to the pictures. You may also use the Left/Right keys. To find the next programme, re-start Channel Set-up by means of the directional keys Left/Right. Encoded channels Select the Decoder option using Up/Down buttons and check the box using the ok button. set option using the Up/Down buttons and choose the character set which will be used for displaying Teletext. 1:Western Europe 2: Eastern Europe 3: Russian, Bulgarian 4: Greek 5:Arabic 6: Ukrainian 7: Belarussian Select the number of the character set, using the table on page 7. Adjusting the Picture Display the PICTURE menu by pressing MENU on the remote control unit: - Once for mono TV sets. " --" appears on the screen. Through the digital keys, enter the tens unit digit, then the unit one (you can also quickly enter the two digits). [. . . ] To the AV2 peritel socket: press the AV key to select AV2 or AV2S (in the case of an S-Video appliance). To the Audio / Video / S-Video sockets: press the AV key to select AV3 or AV3S (in the case of an S-Video appliance). On some models AV3 and AV3S are not accessible; in this case select AV2 or AV2S (in the case of an S-Video appliance). Some appliances (connected to the AV1 or AV2 sockets) automatically produce a switching signal. Therefore you do not need to press the AV key to make a selection. [. . . ]