User manual THOMSON IKT653SD

[. . . ] Your hob is equipped with a child safety device that locks its operation after use or during cooking (See "Using the Child Safety Device" section). Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. [. . . ] If a magnet "sticks" to the bottom of the cookware, it is compatible with induction. For simultaneous use, favour the use of cooking zones located on opposite sides of the hob. On the same side, the use of a cooking zone at maximum power results in an automatic limitation of the other cooking zone on that side, which is indicated in the power level display. to turn it on or change the timing , press the "+" or "-" buttons on the timer. When setting longer cooking times, you can get to 99 very quickly by pressing the "-" button straight away. When the cooking is finished, "0" is displayed and a beep sounds. To cancel this information, press any button for the particular cooking zone being used. To stop the timer manually, press "+" and "-" at the same time or return to 0 using the "-" button. If you do not select a power level, the cooking zone will automatically turn itself off. Press the start/stop button for the cooking zone used or the power "-" button until 0 is displayed. During operation, you can set the power level to "12" -- directly by pressing the "--" button Pre-selected power levels: Button Button Button 6 Low-heat (6) 1 High-heat (10) Boost boiling This button allows you to programme the full cooking cycle for a particular preparation. - When the cooking is finished, the display shows a 0 and a beep sounds roughly every 5 seconds for a few moments. To cancel this information, press any button from the "MEMO" cooking zone. - When using MEMO you can return to the normal function (not MEMO) at any time by pressing on the "-", "+" "pre-selection" buttons to modify your setting or "stop" to stop the cooking. - To replace an existing saved programme, use the procedure detailed in the paragraph: "To programme a cooking cycle". 4 Set the first power level Each new power level setting is then saved as well as how long it will run for. - From 1 to 5 successive cooking phases can be saved in the same "MEMO" cooking cycle. beyond 5 phases , "no" displays , and the programming finishes. - The duration of each phase must be at least 10 seconds for it to be entered into the programme. - The timer can only be used during the last phase of programmed cooking. - The pre-heating function is not available in "MEMO" mode - Using the "MEMO" function takes priority if you are using both cooking zones on the same side of your hob. At high power, the cooking zone on the other side may have its power reduced. [. . . ] Apply a cleaning agent for vitroceramic glass (preferable one with silicone for its protective properties) to the surface. During initial use Operate each cooking zone for 30 minutes with a saucepan full of water. The hob is not working and the indicator lights on the control panel are not on. The hob stops working and it emits a beep approximately every 10 seconds and a or "F7" is displayed. [. . . ]