User manual THOMSON BOT610MXD

[. . . ] -- During pyrolysis, the exposed surfaces become hotter than during normal use. -- Before beginning a pyrolysis cleaning cycle in your oven, remove all parts of your grids, trays and accessories and remove major spill residue. During pyrolysis, exposed surfaces become hotter than during normal use. [. . . ] During fitting and maintenance operations, the appliance must be unplugged from the electrical grid. The electrical connections are made before the appliance is installed in its housing. Ensure that: - the electrical installation has sufficient voltage, - the electrical wires are in good condition, - the diameter of the wires complies with the installation requirements. Your oven must be connected with a (standard) power cable with 3 conductors of 1. 5mm2 (1 live + 1 neutral + earth) which must be connected to a 220-240V~ single-phase 7 grid by means of a 1 live + 1 neutral + earth CEI 60083 standard power socket or via an all-poles cut-off device in compliance with the installation rules. The safety wire (green-yellow) is connected to the appliance's terminal and must be connected to the earth terminal of the electrical set-up. If the connection is to an electric wall socket, it must remain accessible after installation. We cannot be held responsible for any accident resulting from inexistent, defective or incorrect earthing. If the electrical installation in your residence requires any changes in order to hook up your appliance, contact a professional electrician. If the oven malfunctions in any way, unplug the appliance or remove the fuse corresponding to the sector where the oven is hooked up. -- The power cable (H05 RR-F, H05 RN-F or H05 VV-F) must be of sufficient length to be connected to the build-in oven while it sits on the floor in front of the cabinet. To do this the appliance must be disconnected from the electrical network: -- Open the inspection flap located at the lower right of the back cover by unscrewing the two screws, then pivot the inspection flap. -- Loosen the screws from the terminal board and remove the power cord to be replaced. -- Insert the power cable through the side of the cover into the cable clip located to the right of the terminal board. -- The green-yellow coloured earth wire should be connected to the terminal . -- Screw down tightly the screws on the terminal board and check the connection by pulling on each wire. -- Attach the cable with the cable clip located to the right of the terminal board. The grid can be used to hold all dishes and moulds containing foodstuffs to be cooked or browned. [. . . ] If your oven releases an unpleasant odour when cooled after various types of cooking (lamb, fish, grills, etc. Pyrolysis can be performed after one cooking application of this kind, as there is a lot of splattering. You should not wait until the oven is overly coated in grease to initiate a cleaning cycle. [. . . ]