User manual THOMSON 28WF25

[. . . ] If your remote control is equipped with an AUX key then you can also use it to control a second TV set, video recorded, satellite receiver and/or cable box, CD player, tuner, tape recorder or amplifier!Easy programming for the control of your CD PLAYER (not for 5 in 1 model) To programme the remote control to operate your CD PLAYER, proceed as described for the television set. Complete steps 1 to 10 except you must first press and release the SHIFT key followed by holding down the CD key. [. . . ] Code scan If programming using the codes in the enclosed list failed to work then you must next try the automatic code scan. Ensure that the remote control is equipped with 2 new batteries (see step one of easy programming procedure). When using the automatic scan function for the VCR, DVD, CD or TAPE, switch on your device, insert a video tape, DVD, CD or tape cassette and put the unit into ‘Play mode’ i. After seeing the 2 flashes and within 5 seconds, enter the code 0 0 1 . After entering the code the LED will flash twice indicating that the code has been accepted E. During the automatic scanning you can remove your finger or change hands provided it is replaced within 8 seconds. If left off of the key for more than 8 seconds then the remote will revert back to its normal mode. If your TV switches into Stand-By mode during the automatic process then immediately remove your finger from the key and then press the TV key until the LED flashes twice, this will then store the code that the remote control has found. In some cases during the automatic scanning search the remote control might find several codes that appear to operate your TV etc, however, if some of the buttons fail to work properly then it’s possible the remote has found a partially compatible code. In such cases you will need to restart the automatic scanning process (steps B. Please note that once the automatic process is restarted, the remote continues from the last stored code and not at the beginning of code database. €¢ To complete a code scan for the VCR, DVD, CD or TAPE, follow the procedure above but use the key and not the key • To complete a code scan for the TUNER, follow the procedure above but use the key 2 Easy programming for the control of your VIDEO RECORDER To programme the remote control to operate your VIDEO RECORDER, proceed as described above for the television set. Please ensure that you refer to the codes listed under the VIDEO RECORDER section and not the TV section. Easy programming for the control of your SATELLITE RECEIVER To programme the remote control to operate your SATELLITE RECEIVER or CABLE BOX, proceed as described for the television set. [. . . ] To read the currently used code for the control of a VCR, SAT, DVD/AUX, CD, TAPE, TUNER or AMP device, proceed as described above for your TV SET. Complete steps A to F, pressing the VCR , SAT , DVD , CD , TAPE , TUNER or AMP key respectively. TV VCR SAT/CABLE DVD/AUX CD TAPE TUNER AMPLIFIER Programming for AUX devices Depending on the model, you can use your universal remote control to operate a second TV set, video recorder, satellite receiver/cable box, CD player, tape recorder, tuner or amplifier. [. . . ]