User manual TC ELECTRONIC G-FORCE

[. . . ] USER'S MANUAL G-Force GUITAR EFFECTS PROCESSOR IMPORTANT SAFETY INSTRUCTIONS The lightning flash with an arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] At the first movement of the External controller, the parameter will be captured. Preserve - Will preserve the value of the external controller, meaning that the controlled parameter will start this value. Example: You are about to load a preset with an external expression pedal controlling the Delay mix parameter. modifier input, the Delay mix will be reset to the preset value=50% If you selected "Preserve" in the Ext. This parameter should be set to alternating if you are using an expression pedal. Pedal Calibration Press Enter to enable calibration of the External input jack on the back panel of the G-Force. Pedal Curve The response curve of the External 1/4" jack Input can now be adjusted. After the External Input is calibrated, select "Pedal Curve" in the "Utility - Config display", and press ENTER. The "Pedal Curve" parameter is global, and is therefore not changed with presets. Tuner MIDI Out In the Utility menu, a Tuner MIDI Out parameter is added. This parameter should be set to "On" to utilize the Tunerdisplay function in a connected G·Minor pedal. The Tuner MIDI Out parameter MUST be set to Off when performing a MIDI Bulk dump. If MIDI Out is connected to another device than a GMinor it may be advisable to use the "off" position to avoid sending inappropriate MIDI information to that device. User Bank Backup You can backup the User presets of the G-Force to a card or MIDI recording device using these functions. Depending on the size of the PCMCIA card sveral banks on a single card is available. User Bank to Card Insert a PC-card in the Card slot and press Enter twice. All User presets of the G-Force will then be saved to the memory card. Card to User bank Insert a PC-card containing your presets and press Enter twice. All presets will now be stored back into the User bank of the G-Force. User bank to MIDI Connect your G-Force's MIDI out to another G-Force, a sequencer or any other MIDI recordable device. Press Enter twice and the G-Force will perform a MIDI bulk dump of all User presets. 29 UTILITY MIDI to User bank Connect the storing device to the G-Force's MIDI In and press Enter. The G-Force is now ready to receive a MIDI bulk dump containing User presets. [. . . ] Play melodically in time with the echoes for fun and turn on the Drive for a fuzzed sound. Dreamy "attack free" sound designed for slow chord or melody passages. Input level dependent First four repeats become increasingly louder before subsequent repeats decrease in volume. Highly compressed bass sound, designed for ambient/Techno/TR303 emulation. [. . . ]