User manual SWISHER LS12534H12V

[. . . ] LS722H STARTING SERIAL #: L206-010001 Model LS12534H Shown LS728H STARTING SERIAL #: L206-010001 LS10528H STARTING SERIAL #: L206-010001 LS12534H STARTING SERIAL #: L206-010001 LS12534H12V STARTING SERIAL #: L206-010001 LOG SPLITTER Safety Assembly Operation Service and Adjustment Repair Parts PHONE 660-747-8183 Made In The IMPORTANT Read and follow all Safety Precautions and Instructions before operating this equipment. Rev. 06-164 1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093 FAX 660-747-8650 Manufacturing quality lawn care equipment since 1945 12489 USA LIMITED WARRANTY The manufacturer's warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for a period of two (2) year from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. This warranty is subject to the following limitations and exclusions: 1) Engine Warranty All engines utilized on our products have a separate warranty extended to them by the individual engine manufacturer. [. . . ] PLACE COUPLER ON BALL WHEN BALL IS COMPLETELY NESTED IN BALL SOCKET, ROTATE COUPLER HANDLE BACKWARD UNTIL HANDLE IS IN LOCKED POSITION. ALWAYS USE CORRECT BALL SIZE, MAKING SURE BALL IS COMPLETELY INSERTED INTO COUPLER. AVOID SHARP TURNS AND STEEP VERTICAL ANGLES WHEN TOWING. · 5 ASSEMBLY This log splitter has been partially assembled at the factory. Refer to the drawings and part lists should it become necessary to disassemble the unit for repair or replacement of parts. If you believe you have a damaged part please contact customer service immediately at 1-800-222-8183. WARNING: Exercise extreme caution, as parts are very heavy. Refer to uncrating and assembly instructions for assembly procedures. OPERATION INTENDED USE: This log splitter is intended and designed to only split wood. Doing so can cause injury or VOID THE WARRANTY. IMPORTANT: This unit is shipped with oil but without gasoline in the engine. After assembly, see separate Engine Manual for proper fuel and oil recommendations. WARNING: DO NOT START OR RUN THE LOG SPLITTER WITHOUT OIL IN THE ENGINE AND HYDRAULIC RESERVOIR. To stop engine, move throttle lever to "SLOW" for a few seconds then to "STOP. " 6 COLD WEATHER START UP The Cold Weather Clutch enables the engine to be started without having to pull through cold, thickened hydraulic fluid. The suction port on the tank should always be on the lower side of the log splitter. Make sure the log is securely on the foot plate and up against the beam. Depress the valve lever so that the cylinder will drive the push block into the log. If the log has not completely split after the cylinder has reached the end of its extension, retract the cylinder. NOTE: Leaving the valve in the "actuate" position at the end of the stroke may damage the pump. Always use extra care when splitting logs with ends that are not square. NOTE: To extend the life of the hydraulic cylinder, avoid "BOTTOMING OUT" the cylinder. TOWING SAFETY This unit should not be towed on any street, highway, or public road without checking the existing federal, local, and state laws. Any licensing or modifications such as taillights, etc. , need to comply with existing federal, local, or state vehicle requirements is the sole responsibility of the purchaser. See also SAFETY PERCAUTIONS. Turn the fuel shut-off valve if applicable OFF to prevent flooding of the engine while traveling. TOWING AT NIGHT The requirements for taillights are based on States regulations. Some states allow towing at night as long as the towed equipment does not visibly impair the tow vehicle taillights. If a "Statement of Origin" is required in your state, see your local dealer to receive one. HYDRAULIC SAFETY The hydraulic system on your splitter requires careful inspection along with the mechanical parts. [. . . ] Connect and tighten spark plug wire. Engine is hard to start or runs erratic. 2. Fill hydraulic tank to correct fluid level. Cylinder rod is slow or erratic while extending and contracting. 2. See authorized service center. 16 TROUBLESHOOTING CONTINUED Problem Leaking Cylinder Cause 1. See authorized service center. 12 Volt Units Engine will not turn over 1. [. . . ]