User manual SONY XR-C350

[. . . ] â· Be sure not to drop the panel when detaching it from the unit. â· If you detach the panel while the unit is still on, the power will turn off automatically to prevent the speakers from being damaged. â· When you carry the front panel with you, put it in the supplied front panel case. To go forward to go back Note If the POWER SELECT switch on the bottom of the unit is set to the B position, turn the power on first, then set the clock. [. . . ] " Only the stations with relatively strong signals will be tuned in. Tip If you know the frequency of the station you want to listen to, press and hold either side of (SEEK/AMS) for two second, until the desired frequency appears (manual tuning). The POLAR modulation function automatically changes and retunes the stations within 65. If you want to put a blank space between characters, select "_" (underbar). Press (SHIFT), then press (3) (PLAY MODE) repeatedly until "MONO" appears. To go back to the normal mode, select "MONO-OFF" in step 2 above. To return to the normal radio reception, press (LIST) for two seconds. Tip To erase/correct a name, enter "_" (under-bar) for each character. Each time you press (DSPL), the item changes as follows: Tune in any station and press (LIST) for two seconds. Each time you press (SOURCE), the source changes as follows: FM1 n FM2 n MW n LW n CD1 n CD2 n MD1 n MD2 n TAPE Tip You can turn on this unit by pressing (SOURCE) on the rotary remote. Note Once the station name or frequency has been displayed for five seconds, the display goes back to its normal mode. Each time you press (DSPL) during CD playback, the item changes as follows: Play the CD and press (LIST) for two seconds. If you want to put a blank space between characters, select "_" (underbar). To return to the normal CD playback mode, press (LIST) for two seconds. Tip To erase/correct a name, enter "_" (under-bar) for each character. You can use this function for the discs that have been assigned a custom name. For more information on disc names, refer to "Labeling a CD" (page 13). Note If you have not labeled the disc, the bank edit mode does not appear. Press either side of (SEEK/AMS) to select the track number you want to skip and press (5) (ENTER). " If you want to return to "PLAY, " press (5) (ENTER) again. Once a disc name has been displayed for five seconds, the display goes back to its normal playback mode. If the disc information has not been read by the unit, "NOT READ" appears in the display. [. . . ] If the sound does not improve after using a cleaning cassette, please consult your nearest Sony dealer. â· In case of old or inferior cassette tapes, the tape head gets contaminated much more quickly. Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. The unit may not function properly if the connectors between the unit and the front panel are not clean. [. . . ]