User manual SONY XR-4750RDS

[. . . ] If you turn the ignition key to the OFF position without removing the front panel, the caution alarm will beep for a few seconds (only when the POWER SELECT switch is set to the A position). Press (RELEASE) to open up the front panel, and detach the panel by pulling it towards you. If you press (RELEASE) to detach the panel while the unit is still turned on, the power will automatically turn off to protect the speakers from being damaged. If a cassette is already inserted, press (SOURCE) repeatedly until "PLAY" is displayed. [. . . ] Note that turning the "REG" function off might cause the unit to switch to another regional station within the same network. Note This function does not work in the United Kingdom and in some other areas. The Local Link function lets you select other local stations in the area, even though they are not stored in your presets. The unit starts searching for an alternative station with a stronger signal in the same network. Within five seconds, press again the preset number button of the local station. Note When there is no alternative station in the area, and you don't need to search for an alternative station, turn the AF function off by pressing (AF/TA) until "AF" disappears. Each time you press (AF/TA), the displayed items change as follows: z AF z TA z AF TA* Blank Z * Select this to turn on both AF and TA functions. If the station name starts flashing after selecting a station with the AF function on, this indicates that no alternative frequency is available. Press (SEEK/AMS) while the station name is flashing (within eight seconds). The unit starts searching for another frequency with the same PI (Programme Identification) data ("PI seek" appears and no sound is heard). If the unit cannot find another frequency, "NO PI" appears, and the unit returns to the originally selected frequency. The Traffic Announcement (TA) and Traffic Programme (TP) data let you automatically tune in an FM station that is broadcasting traffic announcements even though you are listening to other programme sources. Press (AF/TA) until "TA" or "AF TA" lights up on the display. "TP" lights up on the display when the unit finds a station broadcasting traffic announcements. When the traffic announcement starts, "TA" flashes, then flashing stops when the traffic announcement is over. Tip When the traffic announcement starts while you are listening to another programme source, the unit automatically switches to the announcement and goes back to the original source when the announcement is over. notes · "NO TP" flashes for five seconds if the received station doesn't broadcast traffic announcements. Then, the unit starts searching for a station that does broadcast traffic announcements. When the "EON" indication appears with "TP" on the display, the current station makes use of broadcast traffic announcements of other stations in the same network. When you preset the RDS stations, the unit stores each station's data as well as its frequency, so you don't have to turn on the AF or TA function every time you tune in the preset station. You can select different setting (AF, TA, or both) for individual preset stations, or the same setting for all preset stations. To cancel all traffic announcements, turn off the function by pressing (AF/TA) until "AF" disappears. [. . . ] When the tape is played back for a long period, the cassette may become warm because of the built-in power amplifier. Back of the front panel ¡ Reset button (located on the front side of the unit hidden by the front panel) 3 Press this button when you use this unit for the first time, when you have changed the car battery, or when the buttons of this unit do not function properly. The following checklist will assist in the correction of most problems you may encounter with your unit. Before going through the checklist below, refer to the operating procedures. [. . . ]