User manual SONY RM-V8T

[. . . ] ⷠDo not mix old batteries with new ones or mix different types of batteries together. ⷠIf you take time to insert the batteries or press the buttons when replacing the batteries, the code numbers will be erased. ⷠIf the electrolyte inside the battery should leak, wipe the contaminated area of the battery compartment with a cloth and replace the old batteries with new ones. To prevent the electrolyte from leaking, remove the batteries when you plan not to use the Commander for a long period of time. [. . . ] 2 See the tables in "Component Code numbers, " and find the code number in double figures for the desired component. If more than one code number is listed, use the number that's listed first to complete the steps below. For example, if you're setting up a Philips' VCR, you would use the code number 13. If your component isn't listed, see "Searching for the Correct Code. For example, if you're entering the code for a # # Philips' VCR, you would press and release 1, then press and release 3. 5 Press and release the ENTER button to store the code number in the Commander's ENTER memory. If your video components are connected to an audio system, you probably hear your TV or VCR's sound from the loudspeakers via your receiver, not from your TV speakers. In this case, you need to change the factory preset so that you can control the volume of your video components without first having to switch to the receiver (factory set on AV1 position). To change the factory preset of the volume control, follow the procedures below. You can change this either before or after you set up the Commander to AV2 work with your component. 3 aTo control the component's sound from the loudspeakers via your receiver which is assigned to AV1, press the VOL- button. If the Commander seems to be working properly, you have completed setting up the Commander. If the component does not operate properly, repeat steps 2 and 5 and search for another code. As the searching always start from 01, it will stop again at the same code as the last searching. Pass the code and continue searching until the next code which the component turns off. If you still cannot get the Commander to work properly, see "Troubleshooting. 1 Make sure that the slide switch is set to the VCR position that correspond to your desired component. Be sure to line up the + and ­ on the batteries with the + and ­ on the battery compartment. First, try repeating these setup procedures using the other codes listed for your component (see "Component Code Numbers"). ⷠIf - after trying all the codes listed for your component - you still cannot get the Commander to work properly, try the search method described in "Searching for the Correct Code" Using the Commander will not increase the functions of your TV or other components. The functions of the Commander are limited to the functions of the TV or other components. (The light will automatically turn off if no button is pressed for more than 10 seconds. [. . . ] ** If the deck's commander has one set of tape operating buttons, and has an A/B button for the deck section, use the RECALL button to select Deck A or B. To select track numbers above 10, see the descriptions on the DISP button below. (The light will automatically turn off if no button is pressed for more than 10 seconds. If you have problems setting up or using the Commander: ⷠWhen setting up the Commander, carefully go through the procedures described in "Setting the Code. [. . . ]