User manual SONY MHC-991AV

[. . . ] NOTICE FOR THE CUSTOMERS IN THE UNITED KINGDOM A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or BSI to BS 1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] For example, if you use a 40-minute tape to record a 46-minute CD, the CD player will automatically choose tracks that will fit within the 40-minutes, filling as much of the tape as possible. If the button for the disc tray containing the CD you want to record is not lit green, press DISC SKIP repeatedly so that it lights green. Then the display changes as follows: Then, press § OPEN/CLOSE/ EX-CHANGE again to close the CD tray. If the button for the disc tray containing the CD you want to record is not lit green, press DISC SKIP repeatedly so that it lights green. Each time you press CHECK, the number of the programmed tracks appear in the display. On the remote) to choose the indication that corresponds to the length (in minutes) of your tape. You can adjust the total recording time to the tape length while making a programme. To select the desired tracks beforehand You can record certain tracks (up to 20) first by selecting them before time editing. Choose "HALF" if you want the CD player to half of the total playing time of the CD. You cannot select "HALF" when recording CDs with more than 20 tracks. When you want to reduce the hiss noise in low-level high-frequency signals, press DOLBY NR so that "DOLBY NR B" appears in the display after step 8. When the tape in one deck comes to the end of the front side, it reverses immediately regardless of the tape position in the other deck. When the tape in one deck reaches its end of the front side, it stops until the other tape come to its end, and then both tapes reverse together. If you set DIRECTION MODE to ß or RELAY, recording always stops at the end of the reverse side. You do not have to press DOLBY NR with high speed dubbing Tape in deck A with the side you want to play facing forward. Also, insert a blank tape in deck B with the side you want to record on facing forward. Recording and playback start from the front side of the tape, unless you change the playing direction before recording. To fully enjoy the sound coming from your stereo system, make the following audio adjustments. Your stereo system is provided with 20 different preset effects (music menu) created from different graphic equalizer and surround effect settings. With the press of a single button, you can choose between a variety of effects according to musical genre or use. The personal file function (see "Making a Personal Audio Emphasis File (personal file)") lets you store your own effects. The display changes as follows: display off n DBFB n n DBFB " is more effective than ". [. . . ] Unplug the system from the mains if it is not to be used for an extended period of time. Should any solid object or liquid fall into the component, unplug the stereo system and have the component checked by qualified personnel before operating it any further. On installation Place the stereo system in a location with adequate ventilation to prevent heat buildup in the stereo system. On condensation in the CD player component If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player. [. . . ]