User manual SONY MHC-7900

[. . . ] Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Don't throw away the battery with general house waste, dispose of it correctly as chemical waste. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Load a recordable tape into deck B, then press TAPE A/B repeatedly to select deck B. If you have already loaded the disc, press DISC SKIP/EX-CHANGE to select the disc. When you want to record an album from an MP3 disc, be sure to press PLAY MODE repeatedly to select ALBM, then press ALBUM + or ­ repeatedly to select the desired album before proceeding. ⷠTAPE A/B: To record from this system's tape deck A. Press REC PAUSE/START, then start playing the desired source to record. When the recording is completed, the CD player and the tape deck stop automatically. To record a disc by specifying track order You can record only your favorite CD tracks using Program Play. Between steps 2 and 3, perform steps 2 to 6 of "Creating your own program" (page 13). ⷠRecording stops if you change the function to another one. For recording from the tuner: If noise is heard while recording from the tuner, move the respective antenna to reduce the noise. Selecting the effect from the music menu You can reinforce the bass and create a more powerful sound. t 10MIN t OFF * The system automatically turns off in 100 minutes or after the current disc or tape finishes playing. To start from a specific track, make a program (see "Creating your own program" on page 13). ⷠTape: Load a tape with the side you want to play facing forward. Each time you press the button, the display changes cyclically as follows: The type of timer ("PLAY TIMER"), the start time, the stop time, and the sound source appear in turn, before the original display returns. To timer record, you must first preset the radio station (see "Presetting radio stations" on page 14) and set the clock (see "Setting the clock" on page 9). Set the time to stop recording following the same procedure as step 4. , "TUNER FM 5") appear in turn, before the original display returns. The demonstration display (display window and buttons lighting and flashing even when the system power is off) and the clock display can be turned off to minimize the amount of power consumed during standby (Power Saving Mode). Press DISPLAY repeatedly while the system is off until the demonstration display or the clock display disappears. Each time you press the button, the display switches cyclically as follows: Demonstration display t Clock display* t No display (Power Saving Mode) * The clock is displayed only if you set the clock. You can check the playing time and remaining time of the current track or that of the disc. [. . . ] ⷠIf you continuously use this system at a high volume, the cabinet temperature of the top, side and bottom rises considerably. Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight. ⷠWhen using discs that have glue or similar tacky substance on the label side of the disc or that used a special ink when the label was printed, there is a chance that the disc or label may become attached to parts inside this unit. When this occurs, it may not be possible to remove the disc, and may also cause this unit to malfunction. [. . . ]