User manual SONY MHC-2200CD

[. . . ] Do the following procedure 1 to 4 to hook up your system using the supplied cords and accessories. The type of supplied speakers varies according to the model you purchased (see "Specifications" on page 31). Inserting two size AAA (R03) batteries into the remote With normal use, the batteries should last for about six months. When the remote no longer operates the system, replace both batteries with new ones. [. . . ] Go to the next During play or pause, press track or go back + (to go forward) or = to the start of (to go back). The current track Find a point in a track Select a CD in stop mode Play only the CD you have selected Play all CDs Press and hold down ) or 0 during play and release it at the desired point. Exchange other CDs while playing Adjust the volume You can use a TYPE I (normal) tape. If the disc number you want to record is not displayed, press DISC SKIP repeatedly so that it appears. With the side you want to record on facing forward While recording, do not rewind or fast-forward on the deck B. Press TUNER/BAND repeatedly until the band you want appears in the display. Every time you press the button, the band changes as follows: FM ~ AM Automatic tuning Press and hold 0 or ) in step 2 until the frequency indication starts to change, then release it. Pressing TUNER/BAND when the power is off automatically turns the power on and tunes in the last received station (One Touch Play). â· You can switch from another source to the radio just by pressing TUNER/BAND (Automatic Source Selection). You can record the radio program on a tape by calling up a preset station. With the side you want to record on facing forward To record non-preset stations, use 0 and ) in step 2 to tune in the desired station. Note that you cannot use Tape Select Edit for discs containing over 20 tracks. When the last track for side A finishes playing, the CD player changes to playing pause automatically. Remove the tape from deck A, and insert it again with the side B facing forward. In order to use this function, you must first erase the program (see "Clear the entire program" in the table on page 20). If the disc number you want to record is not displayed, press DISC SKIP repeatedly so that it appears. The required tape length for the currently selected CD appears, followed by the total playing time for sides A and B respectively. The audio emphasis menu lets you select the sound characteristic according to the sound you are listening to. Falling asleep to music -- Sleep Timer You can let the system turn off at the preset time, so you can sleep to the CD. Make sure you have set the clock (see "Step 2: Setting the time"). Every time you press the button, the minute display (the turn-off time) changes as follows: AUTO n 90min n 80min n 70min n . The power turns off when the current CD finishes playback (for up to 100 minutes). [. . . ] â· Do not place the unit in locations where it is; -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Vibrating -- Subject to direct sunlight If the stereo system is brought directly from a cold to a warm location , or is placed in a very damp room, moisture may condense on the lens inside the CD player. Remove the CD and leave the system turned on for about an hour until the moisture evaporates. If you have any questions or problems concerning your stereo system, please consult your nearest Sony dealer. If you later want to reuse the tape for recording, cover the broken tab with adhesive tape. [. . . ]