User manual SONY MDS-JE700

[. . . ] This chapter provides information on the supplied accessories, things you should keep in mind while hooking up the system, and how to connect various audio components to the MD deck. Be sure to read this chapter thoroughly before you actually connect anything to the deck. This MD deck comes with the following items: · Insert two R6 (size-AA) batteries with the + and ­ properly oriented to the markings into the battery compartment. Under normal conditions, the batteries should last for about six months. [. . . ] If you entered the wrong track number Press m/M repeatedly until the wrong track number flashes, then do step 3 above again or press CLEAR to erase the track number. While the deck is stopped and "PROGRAM" lights up, do steps 1 and 2 of "Programming the tracks" on page 27, followed by one of the procedures below: To Repeat step 3 to enter other tracks. The entered track is added to the location where the "0" flashes. Each time you enter a track, the total programme time appears in the display. Press PLAY MODE repeatedly until "PROGRAM" lights up in the display. Press m/M repeatedly until the number of the unwanted track flashes, then press CLEAR. Press m repeatedly until "0" flashes before the first track number, then do steps 3 to 5 of "Programming the tracks" on pages 27 and 28. Press m/M repeatedly until the track number which will precede the new track flashes. press AMS to display flashing "0 , " then do steps 3 to 5 of "Programming the tracks" on pages 27 and 28. Press M repeatedly until "0" flashes after the last track number, then do steps 3 to 5 of "Programming the tracks" on pages 27 and 28. Press m/M repeatedly until the number of the track to be changed flashes, then do steps 3 to 5 of "Programming the tracks" on pages 27 and 28. For further details on the function of each button and control, see the sections on editing operations. About indication which appears while editing You can erase a track or part of a track simply by specifying the number of the track or the portion within a track to be erased. About indications which appear after editing When "TOC" lights up in the display Editing has finished but the TOC (Table of Contents) on the MD has not been updated to reflect the editing results. The editing will be lost if you disconnect the mains lead while the indication is on. The TOC will be updated only when you eject the MD or turn off the MD deck. when "TOC Writing" flashes in the display The deck is updating the TOC. Do not disconnect the mains lead or move the deck while the indication flashes. When you erase a track, all the tracks after the one erased are automatically renumbered. For example, if you erase track number 2, the previous track number 3 becomes track number 2 and the previous track number 4 becomes track number 3, and so on. The deck starts to play the track indicated by the number in the display. If the erased track is the last one on the MD, the track preceding the erased track starts to play. [. . . ] The correct recorded/playing time may not be displayed during playback of MDs recorded in monaural mode. Replace it with another recordable MD with fewer recorded tracks, or erase unnecessary tracks. , There has been a power failure or the mains lead has been disconnected during recording. The deck does not perform synchro-recording with a CD player or video CD player. [. . . ]