User manual SONY LBT-XB80AV

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This stereo system is equipped with the Dolby Pro Logic Surround system* and the Dolby B-type noise reduction system. The AC power cord has been fixed on the rear panel with the plug band temporarily for shipment. [. . . ] If you press DISPLAY/DEMO again, the clock display appears for a few seconds then the display returns to the previous indication. * You can't repeat a single track during Shuffle Play and Program Play. If you want to record on the reverse side, press ª so the indicator on the ª button (for the reverse side) lights up green. When you want to reduce the hiss noise in lowlevel high-frequency signals, press DOLBY NR before step 5 so "DOLBY NR B" appears in the display. Press DIRECTION repeatedly to select A to record on one side or ß (or RELAY) to record on both sides. When programming, make sure the playing times for each side do not exceed the length of one side of the tape. Disc number Track number "STEP" and the programmed playing order appear, followed by the total playing time. Repeat steps 5 through 7 to program additional tracks to be recorded on side A. Note that you cannot use Tape Select Edit for discs containing more than 20 tracks. The required tape length for the CD in the playing position appears, followed by the total playing time for sides A and B. note You cannot use this function when Program Play mode has been set. After clearing the entire program (see "Clear the entire program" in the table on page 25), follow the above procedure. Select A to record on one side, or ß (or RELAY) to record on both sides. Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. With the flash function, you can "flash" the CD sound during playback. Playback at the point you want to start the Loop function, and release to resume normal playback. to adjust the loop length Turn the jog dial while holding LOOP (or press MUSIC MENU B/b while holding LOOP on the remote) to select different loop lengths. Playback at the point you want to start the Flash function, and release to resume normal playback. to adjust the flash length Turn the jog dial while holding FLASH (or press MUSIC MENU B/b while holding FLASH on the remote) to select different flash lengths. To use LOOP and FLASH together With the Wave function, you can fluctuate the graphic equalizer automatically while listening to a source. Listening to a source at the point you want to start the Wave function, and release to resume normal playback. to adjust the wave length Turn the jog dial while holding WAVE to select different wave lengths. [. . . ] If you have any questions or problems concerning your stereo system, please consult your nearest Sony dealer. When the tape heads become dirty -- the sound is distorted -- there is a decrease in sound level -- the sound drops out -- the tape does not erase completely -- the tape does not record Make sure to clean the tape heads before you start an important recording or after playing an old tape. Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight. Demagnetize the tape heads and the metal parts that have contact with the tape every 20 to 30 hours of use with a separately sold demagnetizing cassette. [. . . ]