User manual SONY LBT-XB60

[. . . ] Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] --" appears instead of the total playing time while programming, this means: ­ you have programmed a track numbered over 20, or ­ the total playing time has exceeded 100 minutes. For example, you can record just the songs you want or begin recording from the middle of the tape. If you want to record on the reverse side, press ª so the indicator on the ª button (for the reverse side) lights up green. When you want to reduce the hiss noise in lowlevel high-frequency signals, press DOLBY NR before step 5 so "DOLBY NR B" appears in the display. Press DIRECTION repeatedly to select A to record on one side or ß (or RELAY) to record on both sides. When programming, make sure the playing times for each side do not exceed the length of one side of the tape. Disc number Track number "STEP" and the programmed playing order appear, followed by the total playing time. Select A to record on one side or ß (or RELAY) to record on both sides. Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. Repeat steps 5 through 7 to program additional tracks to be recorded on side A. Note that you cannot use Tape Select Edit for discs containing more than 20 tracks. The required tape length for the CD in the playing position appears, followed by the total playing time for sides A and B. note You cannot use this function when Program Play mode has been set. After clearing the entire program (see "Clear the entire program" in the table on page 22), follow the above procedure. With the flash function, you can "flash" the CD sound during playback. Playback at the point you want to start the Loop function, and release to resume normal playback. to adjust the loop length Turn the jog dial while holding LOOP (or press MUSIC MENU B/b while holding LOOP on the remote) to select different loop lengths. Playback at the point you want to start the Flash function, and release to resume normal playback. to adjust the flash length Turn the jog dial while holding FLASH (or press MUSIC MENU B/b while holding FLASH on the remote) to select different flash lengths. To use LOOP and FLASH together With the Wave function, you can fluctuate the graphic equalizer automatically while listening to a source. Listening to a source at the point you want to start the Wave function, and release to resume normal playback. to adjust the wave length Turn the jog dial while holding WAVE to select different wave lengths. [. . . ] If you run into any problem using this stereo system, use the following checklist. First, check that the power cord is connected firmly and the speakers are connected correctly and firmly. Move the microphone away form the speakers or change the direction of the microphone. The display starts flashing as soon as you plug in the power cord even though you haven't turned on the system (demonstration mode). [. . . ]