User manual SONY LBT-XB6

[. . . ] Refer to them whenever you call upon your Sony dealer regarding this product. To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] To repeat All the tracks on the current CD Press 1/ALL DISCS repeatedly until "1 DISC" appears in the display. 1/ALL DISCS repeatedly until "ALL DISCS" appears in the display. REPEAT repeatedly while playing the track you want to repeat until "REPEAT 1" appears in the display. To check the total playing time and the number of tracks on a CD press DISPLAY/DEMO in stop mode. If you press DISPLAY/DEMO again, the clock display appears for a few seconds then the display returns to the previous indication. * You can't repeat a single track during Shuffle Play and Program Play. Press REPEAT repeatedly until "REPEAT" or "REPEAT 1" disappears from the display. Playing CD tracks in random order -- Shuffle Play You can play all the tracks on one CD or all the CDs in random order. Press PLAY MODE repeatedly until "SHUFFLE" or "PROGRAM" disappears from the display. Press DIRECTION repeatedly to select A to record on one side or ß (or RELAY) to record on both sides. When programming, make sure the playing times for each side do not exceed the length of one side of the tape. Disc number Track number "STEP" and the programmed playing order appear, followed by the total playing time. Select A to record on one side or ß (or RELAY) to record on both sides. Press PLAY MODE repeatedly until "PROGRAM" or "SHUFFLE" disappears from the display. Note that you cannot use Tape Select Edit for discs containing more than 20 tracks. Repeat steps 5 through 7 to program additional tracks to be recorded on side A. The required tape length for the CD in the playing position appears, followed by the total playing time for sides A and B. note You cannot use this function when Program Play mode has been set. After clearing the entire program (see "To clear the entire program" on page 21), follow the above procedure. With the flash function, you can "flash" the CD sound during playback. Playback at the point you want to start the Loop function, and release to resume normal playback. to adjust the loop length Turn the jog dial while holding LOOP (or press MUSIC MENU B/b while holding LOOP on the remote) to select different loop lengths. [. . . ] When the tape heads become dirty -- the sound is distorted -- there is a decrease in sound level -- the sound drops out -- the tape does not erase completely -- the tape does not record Make sure to clean the tape heads before you start an important recording or after playing an old tape. Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight. Demagnetize the tape heads and the metal parts that have contact with the tape every 20 to 30 hours of use with a separately sold demagnetizing cassette. If you run into any problem using this stereo system, use the following checklist. [. . . ]