User manual SONY KV-2185

[. . . ] After 15-30 minutes without a TV signal and without any button being pressed, the TV switches automatically into standby mode. selecting Input source Press repeatedly until the desired input symbol of the source appears on the TV screen. Back to the channel last watched Press to watch the last channel selected (watched for at least 5 seconds). displaying the menu system Press to display the menu on the TV screen. [. . . ] When you move house), select the menu AUTO PROGRAMME in the (SET UP) menu and proceed in the same way as described below in step 1 or, please refer to the section "Automatically Tuning the TV using the TV buttons" of this instruction manual. A new menu appears automatically on the screen asking you to check that the antenna is connected. When the automatic tuning is finished, the Programme Sorting menu appears on the TV screen. If you stop the automatic tuning by pressing the MENU button, the Programme Sorting menu does not appear automatically on the TV screen. After all available channels (TV Broadcast) are captioned and stored, a new menu appears automatically on the screen to change the order in which the channels appear on the screen. However, if you wish to rearrange the order of the channels afterwards, select the menu PROGRAMME SORTING in the (SET UP) menu and proceed in the same way as described in the b) section of this chapter. A) If you do not wish to change the channel order: Your TV is now ready for use. Press the PROGR or button until the channel (TV Broadcast) you wish to rearrange appears on the screen. Press the or button to select the new programme number position for your selected channel (TV Broadcast), then press the OK button. The word CONFIRM is highlighted for a few seconds to confirm that the new programme position is stored. Repeat steps 1 and 2 if you wish to change the order of the other channels on your TV. Although the sound is adjusted at the factory, you can modify it to suit your own taste. Press the button to select the symbol, then press the to enter to the SOUND CONTROL menu. With the cursor highlighting the item you wish to change, press the button. For a bilingual broadcast: A (for channel 1) B (for channel 2) ON OFF Resets sound to the factory preset levels. Press the / or / button to alter the selected item, then press the OK button to store the new adjustment. Press the button to select your desired sound mode (PERSONAL, JAZZ, POP or ROCK). You can select a time period for the TV to switch itself automatically into the standby mode. One minute before the TV switches into standby mode, the time remaining is displayed on the TV screen automatically. Make sure to use a TV channel with a strong signal, otherwise teletext errors may occur. Select the TV channel which carries the teletext service you wish to view. Input three digits for the page number, using the numbered buttons on the remote control. [. . . ] We recommend you tune in the VCR signal to TV programme number `0' using the section "Manually Tuning the TV" of this instruction manual. Connecting Headphones Plug in your headphones to the socket A on the front of the TV set. connecting Decoders Plug in decoders to the socket F on the rear of the TV. Connecting to External Audio Equipment Plug in your Hi-Fi equipment to the G sockets on the rear of the TV if you wish to amplify the audio output from the TV. [. . . ]