User manual SONY KDF-E50A11E

[. . . ] Before operating the TV, please read the "Safety information" section of this manual. To prevent the risk of electric shock, do not insert the plug cut off from the mains lead into a socket outlet. To prevent the risk of fire or electric shock, do not expose the TV set to rain or moisture. Before operating the TV, please read this manual thoroughly and retain it for future reference. [. . . ] 5: RGB input signal through the PC connectors audio input signal through the socket 5. Audio input signal is analogue only if the equipment has been connected using the DVI and audio out socket. You can select the options listed below on the Picture Adjustment menu. When you set the "Picture Mode" option to "Vivid" or "Standard, " you can adjust only "Contrast, " and "Reset. Press m/M to select one of the following picture modes, then press OK. "Brightness", "Colour", "Hue" and "Sharpness" only appear and can be adjusted if "Picture Mode" is set to "Custom". "Warm" only appears and can be adjusted if "Picture Mode" is set to "Custom". This option cannot be used for an input signal from the Y, PB/CB, PR/CR sockets of / 3. Press m/M to select one of the following sound effects, then press OK. Natural: Enhances clarity, detail, and sound presence by using "BBE High definition Sound System*1. " · Dynamic: Intensifies clarity and sound presence for better intelligibility and musical realism by using the "BBE High definition Sound System. If you set "Auto Volume" to "On", "Soud Effect" changes to "Natural". Adjusts higher-pitched sounds (Treble), adjusts lower-pitched sounds (Bass), and emphasizes left or right speaker balance (Balance). A/B/Mono: For a bilingual broadcast, select "A" for sound channel 1, "B" for sound channel 2, or "Mono" for a mono channel, if available. If you select other equipment connected to the TV, set "Dual Sound" to "Stereo, " "A" or "B. Automatically changes the screen format according to the broadcast signal. Even if you have selected "On" or "Off" in "Auto Format", you can always modify the format of the screen by pressing repeatedly. Adjusts the horizontal picture position so that the picture is in the middle of the screen. Press </, to adjust the centre of the picture between -5 and +5, then press OK. tip This option is only available if an RGB source has been connected to the Scarts connectors 1/ 1 or 2/ 2 on the rear of the TV. If you connect a VCR to the / 2 socket, you can then record from the equipment connected to other sockets of the TV. One Time Off: the TV speakers are temporarily turned off allowing you to listen to the sound from external audio equipment. [. . . ] After the used lamp has cooled, place it into the empty box of the replacement lamp. If the lamp is not securely reattached, the self-diagnostic function may be triggered and the POWER/STANDBY indicator flashes three times (see page 9). Take great care when replacing the lamp or plugging in/unplugging the connecting cords. Rough handling may cause the TV to fall, damaging the TV, the TV stand and the floor. [. . . ]