User manual SONY ICF-SW10

[. . . ] As the main plug is used to disconnect the unit from the mains, connect the unit to an easily accessible AC outlet. Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Notice for customers: the following information is only applicable to equipment sold in countries applying EU directives The manufacturer of this product is Sony Corporation, 1-7-1 Konan, Minato-ku, Tokyo, Japan. The Authorized Representative for EMC and product safety is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. [. . . ] Do not place the unit on a surface (a rug, a blanket, etc. ) or near materials (a curtain) which might block the ventilation holes. Should any solid object or liquid fall into the unit, unplug the unit and have it checked by qualified personnel before operating it any further. Troubleshooting Should any problem persist after you have made the following checks, consult your nearest Sony dealer. The CD, radio, iPod or buzzer alarm does not sound at the preset alarm time. Check that "ALARM A" or "ALARM B" is properly displayed. The CD, radio or iPod alarm is activated but no sound comes on at the preset alarm time. Dusty or defective disc -- Clean the disc with an optional cleaning cloth. Take out the CD and leave the CD compartment open for about an hour to allow condensation to evaporate. Notes Do not charge the battery. When you are not going to use the remote commander for a long time, remove the battery to avoid any damage caused by leakage and corrosion. Knowing when to replace the battery A B When the battery becomes weak, "" appears in the display. If a power interruption occurs while the battery is weak, the current time and alarm will be initialized. Note If "12:00" flashes in the display when the unit is connected to AC outlet for the first time, the battery may be weak. In this case, consult your Sony dealer. Only insert up to here. 4 Make sure the AM loop aerial is Adjusting the AM loop aerial connected firmly by pulling softly. Find a place and an orientation that provide good reception. To activate Automatic DST/Summer Time adjustment again, press and hold CLOCK and BRIGHTNESS at the same time. "Auto ON" appears in the display to show that Automatic DST/Summer Time adjustment has been activated. The display returns to the clock. Tip If the FM broadcast is noisy, press MODE to turn off "ST" in the display. The radio becomes clearer although the sound becomes monaural. Notes on radio reception 2 Press CD . 3 Press VOLUME + or ­ repeatedly to adjust the volume. To Pause Resume play after pause Cue to the beginning of the current track (AMS*) Go back at high speed Go forward at high speed Locate a previous track (AMS*) Locate a succeeding track (AMS*) Stop play Press CD "CD" appears in the display to indicate the CD is playing. Keep digital music players or mobile phones away from the AM loop aerial or the FM aerial, as this may lead to interference of reception. When you are listening to the radio with an iPhone connected to the unit, interference with radio reception may occur. When you are listening to the radio while charging an iPod, interference with radio reception may occur. * During playback, this operation goes back to the beginning of the current track. ** These operations are available only when using the supplied remote commander. Notes When inserting an iPod into the unit, be sure to use the universal dock adapter supplied with your iPod or commercially available from Apple Inc. When inserting an iPhone into the unit, be sure to use the universal dock adapter supplied with the unit or commercially available from Apple Inc. When placing or removing the iPod, hold the iPod at the same angle as that of the connector on this unit and do not twist or bend the iPod to prevent connector damage. When placing or removing the iPod, brace the unit with one hand and take care not to press the controls of the iPod by mistake. [. . . ] alarm". ­Preset tuning You can preset 20 stations for FM and 10 stations for AM. 3 Press ALARM TIME SET + or ­ repeatedly to set the year. The year starts to flash in the display. About CD-Rs/CD-RWs This unit is compatible with CD-Rs/CD-RWs but playback capability may vary depending on the quality of the disc, the recording device and application software. 1 Push the iPod lid to open the iPod 2 4 Press CLOCK. 5 Repeat steps 3 and 4 to set the month, And the seconds start incrementing from zero. Notes If you do not press a button for about 1 minute while setting the clock, the clock setting will be cancelled. SUN = Sunday, MON = Monday, TUE = Tuesday, WED = Wednesday, THU = Thursday, FRI = Friday, SAT = Saturday the day, hour, and minute, and then press CLOCK. Music discs encoded with copyright protection technologies This product is designed to play back discs that conform to the Compact Disc (CD) standard. [. . . ]