User manual SONY ICF-CD803

[. . . ] As the main plug is used to disconnect the unit from the mains, connect the unit to an easily accessible AC outlet. Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Notice for customers: the following information is only applicable to equipment sold in countries applying EU directives The manufacturer of this product is Sony Corporation, 1-7-1 Konan, Minato-ku, Tokyo, Japan. The Authorized Representative for EMC and product safety is Sony Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany. [. . . ] Should any solid object or liquid fall into the unit, unplug the unit and have it checked by qualified personnel before operating it any further. Troubleshooting Should any problem persist after you have made the following checks, consult your nearest Sony dealer. The CD, radio, iPod or buzzer alarm does not sound at the preset alarm time. Check that "ALARM A" or "ALARM B" is properly displayed. The CD, radio or iPod alarm is activated but no sound comes on at the preset alarm time. Dusty or defective disc -- Clean the disc with an optional cleaning cloth. Take out the CD and leave the CD compartment open for about an hour to allow condensation to evaporate. Compatible iPod models The compatible iPod models are as follows. Update your iPod to use the latest software before you use it. 4 Make sure the AM loop aerial is Adjusting the AM loop aerial Notes Do not charge the battery. When you are not going to use the remote commander for a long time, remove the battery to avoid any damage caused by leakage and corrosion. connected firmly by pulling softly. Find a place and an orientation that provide good reception. Do not place the AM loop aerial near the unit or other AV equipment, as noise may result. Tip Adjust the direction of the AM loop aerial for best AM broadcast sound. Knowing when to replace the battery When the battery becomes weak, "" appears in the display. If a power interruption occurs while the battery is weak, the current time and alarm will be initialized. Notes The change timing of Automatic DST/Summer Time adjustment employed by the unit (see above) is subjected to variation by circumstances and the law in each country/ region. In such a case, cancel the Automatic DST/Summer Time adjustment and set the DST display manually as necessary. Customers living in a country/region that does not use the daylight saving time (summer time) must cancel Automatic DST/Summer Time adjustment before using the unit. To activate Automatic DST/Summer Time adjustment again, press and hold CLOCK and BRIGHTNESS at the same time. "Auto ON" appears in the display to show that Automatic DST/Summer Time adjustment has been activated. The display returns to the clock. Tip If the FM broadcast is noisy, press MODE to turn off "ST" in the display. The radio becomes clearer although the sound becomes monaural. Notes on radio reception 2 Press CD . 3 Press VOLUME + or ­ repeatedly to adjust the volume. To Pause Resume play after pause Cue to the beginning of the current track (AMS*) Go back at high speed Go forward at high speed Locate a previous track (AMS*) Locate a succeeding track (AMS*) Stop play Press CD "CD" appears in the display to indicate the CD is playing. Keep digital music players or mobile phones away from the AM loop aerial or the FM aerial, as this may lead to interference of reception. When you are listening to the radio with an iPhone connected to the unit, interference with radio reception may occur. When you are listening to the radio while charging an iPod, interference with radio reception may occur. * During playback, this operation goes back to the beginning of the current track. ** These operations are available only when using the supplied remote commander. Notes When placing or removing the iPod, hold the iPod at the same angle as that of the connector on this unit and do not twist or bend the iPod to prevent connector damage. [. . . ] alarm". ­Preset tuning You can preset 20 stations for FM and 10 stations for AM. 3 Press ALARM TIME SET + or ­ repeatedly to set the year. The year starts to flash in the display. About CD-Rs/CD-RWs This unit is compatible with CD-Rs/CD-RWs but playback capability may vary depending on the quality of the disc, the recording device and application software. 2 Press ALARM TIME SET + or ­ 3 Press ALARM TIME SET + or ­ to adjust 4 Press ALARM TIME SET A or B. 5 Press ALARM TIME SET + or ­ to select the desired band. Band ("FM" or "AM") flashes. "VOL" and "PRESET" appears in the display. 4 Press CLOCK. 5 Repeat steps 3 and 4 to set the month, And the seconds start incrementing from zero. Notes If you do not press a button for about 1 minute while setting the clock, the clock setting will be cancelled. [. . . ]