User manual SONY ICF-C203

[. . . ] -Never place the appliance in a confined space, such as a bookcase, or built-in cabinet, unless proper ventilation is provided. Accessories Do not place the appliance on an unstable cart, stand, tripod, bracket, or table. The appliance may fall, causing serious injury to a child or an adult, and serious damage to the appliance. Use only a cart, stand, tripod, bracket, or table recommended by Sony. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. Wall or Ceiling Mounting Troubleshooting Should any problem occur with the unit, make the following checks to determine whether or not servicing is required. [. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Grounding or Polarization This appliance is equipped with a polarized AC power cord plug (a plug having one blade wider than the other), or with a three-wire grounding type plug (a plug having a third pin for grounding). Follow the instructions below: -For the appliance with a polarized AC power cord plug: This plug will fit into the power outlet only one way. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the polarized plug by forcing it in. -For the appliance with a three-wire grounding type AC plug: This plug will only fit into a grounding-type power outlet. If you are unable to insert the plug into the outlet, contact your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the grounding plug. Overloading Do not overload wall outlets, extension cords or convenience receptacles beyond their capacity, since this can result in fire or electric shock. When not in use Unplug the power cord of the appliance from the outlet when left unused for a long period of time. Never pull the plug out by the cord. Power-Cord Protection Route the power cord so that it is not likely to be walked on or pinched by items placed upon or against them, paying particular attention to the plugs, receptacles, and the point where the cord exits from the appliance. Lightning For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the appliance due to lightning and powerline surges. Object and Liquid Entry Never push objects of any kind into the appliance through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the appliance. Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION With 4­ohm loads, both channels driven from 100 ­ 10 000 Hz; rated 1. 0 W per channelminimum RMS power, with no more than 10 % total harmonic distortion in AC operation. Cleaning Unplug the appliance from the wall outlet before cleaning or polishing it. " NAP indicator Various Modes of CD Playback You can play tracks repeatedly or in random order. Each press changes the play mode as follows: 3 4 Press ALARM SET BUZZER. The minute will flash. Tuning in to a Preset Station 1 Press RADIO·BAND to turn on the 2 3 4 radio. Adjust the volume using VOLUME. After about 10 seconds, the display will return to the previous display but the PRESET TUNING button number will remain. Note Holding down the desired PRESET TUNING button for more than a few seconds in step 3 will replace the previous station on the PRESET TUNING button with the station you tuned in to. Repeat step 2 to set the minute and press ALARM SET BUZZER. Two short beeps will confirm the setting. To Stop NAP Timer Press NAP or OFF x·ALARM RESET to turn off the buzzer. To Set the Alarm Mode Before setting the alarm mode, be sure to set the alarm time. (See "To Set the Alarm Time". ) Repeat the pressing of ALARM MODE to select the alarm mode you want. Every time you press ALARM MODE, CD/RADIO/BUZZER indicator changes in the order as follows: Display Indication none Play mode (normal play) To Deactive NAP Timer Press NAP. The NAP indicator and " "go off. All the tracks are played once. m "REP 1" (single repeat) A single track is played repeatedly. m CD RADIO BUZZER OFF CD+RADIO CD+BUZZER Setting the Sleep Timer You can enjoy falling asleep to the CD or the radio using the built-in sleep timer that turns off the CD or the radio automatically after a preset duration. Every push changes the display as follows: off (current time) 15 90 30 60 "REP ALL" (all repeat) All the tracks are played repeatedly. m "SHUFFLE" The CD u button has a tactile dot. (shuffle play) All the tracks are played once in random order. [. . . ] In step 5, when you press CLOCK after the minute setting to activate the clock, the seconds start counting from zero. To change the display to the daylight saving time (summer time) indication Press D. S. T. /SUMMER T. " " is displayed and the time indication changes to summer time. again. When you release TUNE/TIME SET + or ­ after locating your desired station, the display returns to the previous display after about 10 seconds. [. . . ]