User manual SONY DCR-TRV285E

[. . . ] Before operating the unit, please read this manual thoroughly, and retain it for future reference. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ] LINK cable (optional) to connect your camcorder to other device via the DV Interface. The video and sound signals are transmitted digitally, producing high quality pictures. You can copy and edit the picture played back on your camcorder to other recording devices (such as VCRs). For TRV270E/285E: When your camcorder is connected to the VCR via the DV Interface, you cannot record the title or indicators. LINK cable, the recorded picture becomes rough when a picture is paused on your camcorder while recording to a VCR. z Tip · For TRV238E/438E: To prevent deterioration of pictures, set [EDIT] to [ON] in the (PLAYER SET) menu before dubbing (p. When dubbing using the A/V connecting cable, press DISPLAY/BATT INFO to hide indicators such as time code (p. For TRV270E/285E: When connected using the A/V connecting cable, to record the date/time and camera settings data, have it displayed on screen (p. You can control VCR for dubbing with your camcorder easily with the VCR connected to the camcorder. Step 1: Preparing your camcorder and VCR for operation Follow the steps below when you are performing the Easy Dubbing for the first time. You can skip this setting if you have set up the VCR by the following procedure before. b Note · You cannot perform the Easy Dubbing on a VCR that does not support [IR SETUP] codes. Turn the SEL/PUSH EXEC dial to select [IR SETUP], then press the dial. When you connect with an A/V connecting cable, you need to check the [IR SETUP] code signal to see if your VCR can be operated by your camcorder (infrared ray emitter). Turn the SEL/PUSH EXEC dial to select the [IR SETUP] code of your VCR, then press the dial. When there is more than one code listed for the manufacturer of your VCR, try each code and find the most appropriate one. Turn the SEL/PUSH EXEC dial to select [PAUSE MODE], then press the dial. Turn the SEL/PUSH EXEC dial to select the mode to cancel recording pause on the VCR, then press the dial. Camcorder towards the remote sensor on your VCR, from about 30 cm (12 in. The following [IR SETUP] codes are recorded on your camcorder by default. When recording fails to start, select another [IR SETUP] code and try again. Turn the SEL/PUSH EXEC dial to select the desired title, then press the dial. [. . . ] The rechargeable battery will be fully discharged in about 3 months if you do not use your camcorder at all. However, even if the pre-installed rechargeable battery is not charged, the camcorder operation will not be affected as long as you are not recording the date. Procedures Connect your camcorder to a wall socket using the supplied AC Adaptor, and leave it with the POWER switch set to (CHG) OFF for more than 24 hours. Do not add excessive pressure on the LCD screen, as it may cause damage. [. . . ]