User manual SONY CPJ-200

[. . . ] For the customers in the USA This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Also, the ON/STANDBY indicator flashes quickly for the first 45 seconds. During this time, you will not be able to light up the ON/STANDBY indicator again with the ?Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red. When you cannot confirm the onscreen message When you cannot confirm the on-screen message under certain conditions, you can turn off the power by holding the ?The internal circuitry of the Off & Go and Direct Power On/Off functions may cause the fan to continue to operate for a short time even after the ?/1 key is pressed to turn off the power and the ON/STANDBY indicator changes to red. You can select one of fifteen languages for displaying the menu and other on-screen displays. Press the v or V key to select the MENU SETTING menu, then press the B or ENTER key. Press the v or V key to select "Language, " then press the B or ENTER key. Press the v, V, b or B key to select a language, then press the ENTER key. The menu disappears automatically if a key is not pressed for one minute. However, if the unit has been on for less than 15 minutes, the fan might not begin to turn as a result of inadequate charging. In that case, follow the procedure for turning off the power as described in "Turning Off the Power" on page 19. Just pressing the RESET key returns the image back to its original size immediately. By pressing the + key repeatedly, the image size (ratio of enlargement: max. The projector is equipped with an on-screen menu for making various adjustments and settings. You can hide this indicator using "Status" on the MENU SETTING menu. When changing the adjustment level: To increase the number, press the v or B key. When changing the setting: Press the v or V key to change the setting. The menu disappears automatically if a key is not pressed for one minute. Select the item that you want to reset, and then pres the RESET key on the Remote Commander. " appears on the screen and the setting of the item that you have selected is reset to its factory preset value. [. . . ] If the LAMP/COVER indicator still lights even after you have replaced the lamp, the electrical system may break down. Both the LAMP/COVER and TEMP/FAN indicators c Consult with qualified Sony personnel. Use the list below to check the meaning of the messages displayed on the screen. C When using the projector at an altitude of 1, 500 m or higher, set "High Altitude Mode" on the INSTALL SETTING menu to "On" (see page 32). [. . . ]