User manual SONY CFD-757

[. . . ] The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press the button once at a time. Indicates an FM stereo broadcast. 6 Basic Operations CFD-757. E_3-858-522-6X. U/CA/AU6/TW Use these buttons for additional operations POWER Basic Operations VOLUME +/­ Tips · If the FM broadcast is noisy, press MODE until "Mono" appears in the display and the radio will play in monaural. The player turns on automatically and starts playing the previous station. To Adjust the volume Turn on/off the radio Press VOLUME +/­ POWER To improve broadcast reception Reorient the antenna for FM. Reorient the player itself for AM. for FM for AM Basic Operations 7 CFD-757. E_3-858-522-6X. U/CA/AU6/TW Playing a tape 1 2 Connect the supplied AC power cord (see page 23). 1 Press p6 to open the tape compartment and insert a recorded tape. [. . . ] · When you've selected REP ALL, SHUF REP or PGM REP, press ( . To cancel Repeat Play Press MODE until "REP" disappears in the display. 14 The CD Player CFD-757. E_3-858-522-6X. U/CA/AU6/TW Creating your own program (Program Play) The CD Player You can make a program of up to 20 tracks in the order you want them to be played. Number buttons MODE ( p Tips · You can select the track on the player. · You can play the same program again, since the program is saved until you open the CD compartment. After you've created the program, insert a blank tape into the tape compartment and press r to start recording. 1 2 3 Press p. Press the number buttons for the tracks you want to program in the order you want. You can program up to 20 tracks. Programed track Playing order 4 Press ( to start program play. continued The CD Player 15 CFD-757. E_3-858-522-6X. U/CA/AU6/TW Creating your own program (Program Play) (continued) To cancel Program Play Press MODE until "PGM" disappears in the display. To check the order of tracks before play Press DISPLAY/ENTER on the player. Every time you press the button, the track number appears in the programed order. To change the current program Press p once if the CD is stopped and twice if the CD is playing. Then create a new program following the programing procedure. 16 The CD Player CFD-757. E_3-858-522-6X. U/CA/AU6/TW The Radio Presetting radio stations You can store radio stations into the player's memory. You can preset up to 20 radio stations, 10 for each FM or AM in any order. The Radio Number buttons BAND TUNE +/­ Tip To preset radio stations on the player, proceed as follows: 1 Select the band and tune in a station you want. 3 Decide on a preset number for the station (1 to 10) by pressing PRESET +/­. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. · The nameplate indicating operating voltage, power consumption, etc. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place anything within 10 mm of the side of the cabinet. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. · If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. · Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. On operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. In this case, remove the CD and wait about an hour for the moisture to evaporate. · If the player has not been used for a long time, set it in the playback mode to warm it up for a few minutes before inserting a cassette. If you have any questions or problems concerning your player, please consult your nearest Sony dealer. 26 Additional Information CFD-757. E_3-858-522-6X. U/CA/AU6/TW Notes on CDs · Before playing, clean the CD with a cleaning cloth. [. . . ] · Move closer to the player when using the remote. Tape Player Timer Remote The tape does not record. The audio is weak/The audio quality is poor. The sound is distorted. The timer does not operate. The remote does not function. After trying the above remedies, if the player still does not function properly, unplug the AC power cord and batteries. After all the indications in the display disappear, plug the power cord and insert the batteries again. If the problem persists, please consult your nearest Sony dealer. Additional Information 29 CFD-757. E_3-858-522-6X. U/CA/AU6/TW Maintenance Cleaning the lens If the lens becomes dirty, it may cause a skipping of sound during CD operation. Cleaning the tape heads and tape path Wipe the heads, the pinch roller and the capstan with a cleaning swab slightly moistened with cleaning fluid or alcohol after every 10 hours of operation for optimum playback and recording quality. [. . . ]