User manual SONY CFD-565

[. . . ] Break off the cassette tab from side A or B to prevent accidental recording. If you want to reuse the tape for recording, cover the broken tab with adhesive tape. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. If you should lose the fuse cover, please contact your nearest Sony service station. [. . . ] Take out the CD and leave the CD compartment open for about an hour to dry moisture condensation. There is a problem with the quality of the CDR/CD-RW, recording device, or application software. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the appliance. The sound may drop out or noise may be heard when using poor quality CD-Rs/CDRWs or if there is a problem with the recording device or application software. Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. The ventilation holes must be unobstructed for the player to operate properly and prolong the life of its components. If the player is left in a car parked in the sun, be sure to choose a location in the car where the player will not be subjected to the direct rays of the sun. Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the player to prevent possible damage from the magnet. Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car. Do not stick paper or sticker on the CD, nor scratch the surface of the CD. To stop playback pause playback go to the next track go back to the previous track remove the CD locate a point while listening to the sound locate a point while observing the display locate a specific track directly* To record from the CD player Press x and load a CD (See "Playing a CD"). After changing the tuning interval, you need to reset your preset AM/MW radio stations. * You cannot locate a specific track if "SHUF" or "PGM" is lit in the display. To locate a track numbered over 10, press >10 first, then the corresponding number buttons on the remote. To check the total track number and playing time The display changes as follows: t the current track number and playing time r the current track number and the remaining time on the current track* r the number of tracks left and remaining time on the CD Programmed track Pista programada Playing order Orden de reproducción * For a track whose number is more than 20, the remaining time appears as "- -:- -" in the display. You can preset up to 30 radio stations (CFD-565), 20 for FM and 10 for AM in any order, or 40 radio stations (CFD-EX35L), 20 for FM and 10 for MW and LW in any order. The stations are stored in memory from the lower frequencies to the higher ones. To turn on/off the power You need to preset a station with a weak signal manually. 5 Press PRESET + or ­ until the preset number you want for the station flashes in the display. CFD-EX35L only: If the MW/LW programme makes a whistling sound after you've pressed z in step 4, press MODE to select the position of ISS (Interference Suppress Switch) that most decreases the noise. For the best results, use the AC power as a power source for recording. [. . . ] Press SLEEP to select the minutes until the player goes off automatically. Each time you press the button, the indication changes as follows: "60" t "90" t "120" t "OFF" t "10" t "20" t "30". 3 Hold down the number buttons that you want to preset the new station on for about 2 seconds. To select the preset number over 10, press >10 first, then the corresponding number buttons. [. . . ]