User manual SONY CFD-460

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION The use of optical instruments with this product will increase eye hazard. Owner's Record The model number is located at the bottom and the serial number is located in the battery compartment. [. . . ] The player turns on (direct power-on) and starts playing. Display 8 Basic Operations Use these buttons for additional operations 0 ) p6 P VOL + VOL ­ POWER Basic Operations Tip Next time you want to listen to a tape, just press (. 1 Press MONO/ST ISS· PLAY MODE until "PGM REP" appears. 3 Press ^. all the tracks tracks in random order programmed tracks To cancel Repeat Play Press MONO/ST ISS·PLAY MODE until "REP" disappears from the display. 14 The CD Player Playing tracks in random order (Shuffle Play) ^ p The CD Player You can play tracks in random order. MONO/ST ISS PLAY MODE On the remote 1 Press p. 2 Press MODE repeatedly until "SHUF" appears in the display. Press MONO/ST ISS·PLAY MODE until "SHUF" appears in the display. Press ^ to start shuffle play. To cancel Shuffle Play Press MONO/ST ISS·PLAY MODE until "SHUF" disappears from the display. The CD Player 15 Creating your own program (Program Play) You can arrange the playing order of up to 20 tracks on a CD. = ^ + p DISPLAY ENTER MEM MONO/ST ISS PLAY MODE On the remote 1 Press p. 3 Press the number buttons for the tracks you want to program in the order you want. Press MONO/ST ISS·PLAY MODE until "PGM" appears in the display. Press the = or + then press DISPLAY· ENTER MEM for the tracks you want to program in the order you want. Programed track Playing order The programed tracks appear in the music calender. 4 Press ^ to start program play. 16 The CD Player Tips · You can play the same program again, since the program is saved until you open the CD tray. After you've created the program, insert a blank tape and press r to start recording. To cancel Program Play Press MONO/ST ISS·PLAY MODE until "PGM" disappears from the display. To check the order of tracks before play Press DISPLAY·ENTER MEM. Before you replace the batteries, be sure to take out the CD from the player. 4 Using the player on batteries Insert six size D (R20) batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. 26 Setting Up Selecting the audio emphasis (Sound Mode/MEGA BASS) You can adjust the audio emphasis of the sound you are listening to. PRESET SOUND MODE MEGA BASS Setting Up On the remote Press SOUND repeatedly to select the audio emphasis you want. Selecting the sound characteristic Press one of the PRESET SOUND MODE buttons to select the audio emphasis you want. Choose OFF ROCK POP LIVE VOCAL To get the whole dynamic range for music such as classical music powerful, clean sounds, emphasizing low and high range audio light, bright sounds emphasizing high and middle range audio percussive sounds, emphasizing bass audio the presence of vocals, stressing middle range audio Reinforcing the bass sound Press MEGA BASS. To return to normal sound, press the button again. Setting Up 27 Additional Information Precautions On safety · As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. · Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further. On power sources · For AC operation, use the supplied AC power cord; do not use any other type. · The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off. · Unplug the player from the wall outlet when it is not to be used for an extended period of time. · When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion. · The nameplate indicating operating voltage, power consumption, etc. On placement · Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. · Do not place anything within 10 mm of the side of the cabinet. [. . . ] · Do not stick paper or sticker on the CD, nor scratch the surface of the CD. If there is a scratch, dirt or fingerprints on the CD, it may cause tracking error. Tab for side B Tab for side A · The use of a cassette with more than 90 minutes of play time is not recommended except for long, continuous recording or playback. Additional Information 29 Troubleshooting Symptom The power is not on. · You cannot turn on the player with the remote when you operate the player on batteries. · Make sure the function you want to use appears in the display window. [. . . ]