User manual SONY CFD-S28L

[. . . ] Press VOLUME +, ­ (VOL +, ­ on the remote, CFD-S38/ S38L/S55 only) p ^ (P on the remote, CFD-S38/S38L/S55 only) Press the button again to resume play after pause. Go to the next track go back to the previous track remove the CD turn on/off the player Press RADIO BAND until the band you want appears in the display (direct power-on). The player automatically scans the radio frequencies and stops when it finds a clear station. If you can't tune in a station, press the button repeatedly to change the frequency step by step. [. . . ] 4 Press PRESET + or ­ until the preset number (1 to 10) you want for the station flashes in the music calender. Once you've preset the stations, use the number buttons on the remote or PRESET +/­ on the player to tune in to your favorite stations. Make sure you have set the clock ("Setting the clock" on page 21). Before you begin, make sure the t (clock) indication is not lit in the display. To play the radio a CD Do this Tune in a station Insert a CD Set the timer to the hour you want the music to start by pressing TIME SET· Set the timer to the hour and the minutes you want the music to go off. To exit the standby mode, press STANDBY to make tdisappear from the display. Then the power will go off at the preset time, and the player will enter into the standby mode. To check/change when the playback will start Press TIMER, then DISPLAY ENT· mEMORY. Each time you press DISPLAY ENT· To use the player before a timer playback starts Just turn on the player, and then you can use it. If you turn off the player before the preset time, timer playback will start at the preset time. In case of the radio, however, if you listen to the station which is different from the one you tuned in in step 1 on page 22, you will hear that station at the preset time. Make sure to tune in the station you want to listen to before you turn off the player. Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90, and 120 minutes, allowing you to fall asleep while listening to music. Set the waking up timer first (see page 22), turn on the power, and then set the sleeping timer. Note When you are playing a tape using this function: If the tape length of one side is longer than the set time, the player will not go off until the tape reaches the end. " Press SLEEP to select the minutes until the player goes off automatically. Each time you press the button, the indication changes as follows: "60" n "90" n "120" n no indication n "10" n "20" n "30. To cancel the sleep function Press OPERATE (or POWER) to turn off the power. Insert one end of the supplied AC power cord to the AC IN socket located at the rear of the player, and the other end to the wall outlet. Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones. Note CFD-S38/S38L/S55 only: When you operate the player on batteries, you cannot turn on the player using the remote. [. . . ] Demagnetizing the tape heads After 20 to 30 hours of use, enough residual magnetism will have built up on the tape heads to begin to cause loss of high frequency sound and hiss. At this time, you should demagnetize the heads and all metal parts in the tape path with a commercially available tape head demagnetizer. Cleaning the cabinet Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine. [. . . ]