User manual SONY CDX-S22

[. . . ] Getting Started Resetting the unit Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit. Detach the front panel and press the RESET button with a pointed object, such as a ballpoint pen. If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. Do not drop or put excessive pressure on the front panel and display window. [. . . ] With the card remote commander In step 2, to select the programme type, press M or m. Note You cannot use this function in countries/regions where no PTY data is available. Other functions Changing the sound settings With the card remote commander In step 3, to adjust the selected item, press <, M, , or m. With the card remote commander In step 2, to select the setup item, press M or m. After 3 seconds, the setting is complete and the display returns to normal play/reception mode. The following items can be set (follow the page reference for details): "z" indicates the default settings. With the card remote commander In step 2, to adjust the selected item, press <, M, , or m. "CUSTOM" of EQ3 allows you to make your own equalizer settings. The volume level is adjustable in 1 dB steps, from ­10 dB to +10 dB. After 3 seconds, the setting is complete and the display returns to normal play/reception mode. Card remote commander RM-X114 location of controls The corresponding buttons on the card remote commander control the same functions as those on this unit. ) When the battery becomes weak, the range of the card remote commander becomes shorter. The following buttons on the card remote commander have also different buttons/functions from the unit. (For details of other operations, see "With the card remote commander" on each pages. (For details of other operations, see "With the card remote commander" on each pages. Note If the unit is turned off and the display disappears, it cannot be operated with the card remote commander unless (SOURCE) on the unit is pressed, or a disc is inserted to activate the unit first. ⷠWipe the battery with a dry cloth to assure a good contact. ⷠBe sure to observe the correct polarity when installing the battery. ⷠDo not hold the battery with metallic tweezers, otherwise a short-circuit may occur. If your car has been parked in direct sunlight, allow the unit to cool off before operating it. ⷠPower aerial will extend automatically while the unit is operating. Before playing, clean the discs with a commercially available cleaning cloth. [. . . ] The leads are not matched correctly with the car's accessory power connector. Connect a power aerial control lead (blue) or accessory power supply lead (red) to the power supply lead of a car's aerial booster (only when your car has built-in FM/MW/LW aerial in the rear/side glass). T Tuning stops too frequently: Press (SENS) until "LOCAL-ON" appears. T Tuning does not stop at a station: Press (SENS) repeatedly until "MONO-ON" or "MONO-OFF" (FM), or "LOCAL-OFF" (MW/ LW) appears. [. . . ]